20 Most Recent 2008 Mitsubishi Endeavor Questions & Answers

I have a 2008 Mitsubishi Endeavor. My son put coins on the lighter and after he put them inside i couldn't use it anymore. I don't know where is the fuse panel at?

The very first thing that you need to do is have the engine control computers fault codes checked. The idle speed is 100% computer controlled.

Tiene correa o banda tensora.

Can you reach from back.

Remove belt and spin each pulley to check for smoothness or noise.

Try to reprogram key by turn key on and off 3 to 4 times and try again

It is under the driver's kick panel. Occasionally, they are under the passenger's kick panel. (Remember, the Japanese drive from the right-hand side and some car designs are not switched over completely for our LHD in NAFTA countries and Continental Europe.) The socket has 21 pins on it as I remember.

Sounds like you have a weak battery..try giving it a good charge and try again many times engines will not start with a battery that turns the engine over but not fast enough to start.. Good luck.

is it electric ? if so check the fuse , the switch if both ok then i suspect it is the window actuator /motor assembly

2008? does car run? and move? is the Check engine lamp glowing , moving? yes, and you scanned it and got just ONE DTC? P0551, (which engine option do you have?) that code is power steering fail. check fuses first use a scan tool to reset the errors test drive car see if it returns. same answer any car. if comes back , the sensor is bad, or its wires fell off. or you are turning the steering real hard in to a curb and overloaded it. in the later case, stop that, or we tell you mum.

Does it do it with the A/C too?? If so it could be a broken fan wheel in the blower.. or a piece of trash in the blower housing.. like a leaf.. Post a comment so we know what you find..