2007 Fiat X1/9 - Answered Questions & Fixed issues

Possibly a disconnected sensor.

change the sealed beam unit

jack car up support it ,disconnect battery cable+,locate starter 2 bolts holds it to block,remove them ,wire from the battery will be connected to starter turn starter until it releases from block lower it slowly take wrench5/16 or 10mm and disconnectfrom starter,put backwards

Try a dealer.

Page 115 in the manual if you go to the following link.

http://www.scribd.com/doc/49755408/Fiat-500-Owners-Manual

Let me understand; put diesel fuel in a car designed for gasoline? If so your looking at a whirl of other issues. Diesel fuel is not as combustable as gasoline and requires much more compression (almost double) then a gasoline vehicle, also diesel fuel is more oily and will gel up in cold temps which is why there is a heater on the motor to warm the fuel before entering the combustion chamber and third the engine needs to be pre warmed (glow plugs) to help ignite the diesel fuel. I would start by flushing the engines fuel system/tank and hopefully the injectors/fuel pump werent damaged/clogged. Its prob smoking because the fuel isnt igniting 100% and its like burning oil, it doesn't combust/explode like gasoline it just burns black due to incomplete combustion.

something is wrong with the engine ,could be anything from a vacumn pipe off to the vapour control for the fuel tank ,ask a local mechanic to have a look for you is the best advice i can give as too many variables

Dear Sir,
As you said, you found light on cluster some like bulb in yellow. it means any of your light is not working, if you wait after put ignition on don't start car cluster will show you massage which light is not working, just replace same bulb.if any issue please let me know. thanks.
Yogesh

the mechanism is burried deep inside the acctual seat. there will be an access fold which consists of a piece of plastic which is folded at the botom of the back of the seat which should untuck so to speak and allow you to access the back enough to see the offending clasp

you have to replace the vehicle speed sensor located at the right side tranny axle out put shaft.it is above the hole where the right front axle goes into the transmission.

thats because it is clutch slip ,auto boxes have a clutch in them ,the front clutch ,also check the oil level

ecm tells it when to fire

There is a possibility that your fuel transfer pump has quit and fuel is getting to your engine by gravity only. Have your tranfer pump flow rate tested. Also renew your primary fuel filter.

their is none

Well it can majorly mess things up
If you put diesel in a gas engine it will die allmost imediately.

if you put gas in a diesel engine, a little wont hurt, but if you filled up, then it could damgae the engine horribly.

If you simply put in the wrong grade ie. 87 octane instead of 93, then dont worry it wont hurt a thing. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

theres a fuse that goes to guages...check it first...its in the fuse panel....check owners manual

The fuel tank has lines that go out of it for different jobs. One of this plastic lines helps the gas fumes to breathe out in to the atmosphere throu a filter, so if this line is clogged for some reason no air can get out when you pump the gas in, so it spills it out. Locate this line and replace or unclogge it and hopefully this will cure you problem

check spark plug gaps are set correctly and that leads are in correct order if you took all leads off at same time its easy to mess up just one or two

You may need a new ignition switch but without testing its just a guess. The instrument cluster may of fried if the ignition switch has a short in it.

you might need tio check the grounding of course it is possible damage or try to check the fuse it is located to your front pannel board. and the connect from the main source for the supply