20 Most Recent 2007 Infiniti M45 Sedan New Cars Questions & Answers

The cover needs to be pryed off gentle, if it breaks then it doesnt matter if you are replacing it, its held in by plastic clips molded into the cover, you will need to use a small plastic wedge to remove the cover from the mirror. take a look at the new cover and you will see how its held on.good day.

This could be a number of things and a car is difficult to diagnose from sounds as th nature of it means that the sound does not always come from where it sounds like it is. Try - wheel bearings (usually a high pitched squeal) - Big or little end bearings if the engine has been run low on oil. It is an auto I assume so could be gear box. It could be something really simple like engine mounts and the vibrations of the engine are passing to the metal body as the rubber has come away. W+Could you possibly video it and post?

check ur mountings and drive shafts or propshaft

Have the sound investigated immediately as from your description it may be a major engine failure in the making. If it is then the fix will be another engine and that will be expensive.;

The rotors are warped and need to be replaced or machined. If the steering wheel is shaking when stopping, then the front rotors are warped. If the whole car shakes, then it's the back ones. Most typical cause of warped front rotors is actually the back brakes not functioning correctly (or at all).

Just guessing mind you but I am inclined to be thinking that the engine has a serious internal (terminal) problem. If the noise is that bad you should be sitting when a mechanic gives you a quote to repair it.

The remote most likely just needs the battery replaced. Most of them use a small watch battery once replaced it will work fine. As for the interior light if it is set to turn on when the doors open and is not the bulb or the fuse may be blown. I would say it is most likely the bulb.

Thank you for using FixYa! Please Rate!

yes. replace the fuel pump

Check alternator. I think you got a bad one.

disconnected wire or bad sensor

you might need new valve guides

gas tank has the pump in it and the float leaver is stuck .turn car on and hit on the bottom of gas tank that might help release it

probably has a ballas that went out. changing the lights on that product is usually a pain in the ****. but over time some ballases will go out. simple fix but they will have to test voltage until the find where the problems begins.