20 Most Recent 2008 Infiniti QX56 Questions & Answers

There are quite a few reasons a key fob might stop working, I just wish I could tell you what they are :) I can tell you there are some tricks to getting a key fob to work again. 1) Change the battery I know you stated you tried this, but make sure you installed the battery correctly. Batteries don't last forever, you'll be surprised how often it's just a dead battery! Click here for a video on how to open a GM key fob, or search our YouTube channel on how to change a battery for your specific year, make, and model! 2) Wipe the board The board inside your remote can get a lot more filthy than you think! When the board is dirty it can prohibit the contact to the circuit board when you push down on the button. Simply wiping the circuit board off can make your key fob like new again! 3) The old car battery reset trick I know this sounds absurd, but it works sometimes and is worth trying. If you exhausted all of the options above, disconnect bot terminals on your car battery for 10 minutes. Then reconnect them and try your key fob. This has worked for many people and I have no idea why. If you do, please comment below to explain. 4)New fob! It might be time for a new key fob! No need to dread over the expensive costs of a new key fob, at Keyless Entry Remote Fob Inc., you can get a refurbished one for a very affordable price! You won't even be able to tell the difference. Just search your vehicle make, model, and year to find your key fob or give us a call at 402-671-5100.

discnt your battery for 2 minuets with the engine turned off, the check all your fuses too

The disc brakes are warped.

Warped brake rotor usually cause high vibration at high speeds. But you can also feel it at lower speeds. But bad ball joints and tie rod end will cause vibration at high speeds. Ball joints will pop at pot holes, sometimes. Tie rods can be felt in the steering wheel at a stop. Move the wheel slightly to the left and right, you can feel/hear a tap as you turn it.

This is what I found listed that needs to be checked after battery replacement. Not an autozone job for sure.

ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL

ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : SpecialRepair Requirement

INFOID:0000000006095112

Required Procedure After Battery Disconnection

System Item Reference

Engine Control Idle Air Volume Learning Refer to

EC-18.

Brake Control Steering Angle Sensor Neutral Position Refer to

BRC-8.

Power Window Control Power Window System Initialization Refer to TSB.

Body, Lock & Security Automatic Back Door Initialization Refer to

DLK-9.

Roof Sunroof Memory Reset/Initialization Refer to

RF-5.

Seats Automatic Drive Positioner System Initialization Refer to Owner's Manual.

Audio-Visual System

Audio (Radio Preset) Refer to Owner's Manual.

Navigation System Refer to Owner's Manual. Rear View Monitor Guiding Line Adjustment Refer to AV-7.

Wiggle the steering wheel while trying to turn the key?

Remove the lamp assy from car,blow outmoisture with air hose,if it comes back replace assyMake sure the lamps are sealed properlyin the back