20 Most Recent
2007 Hyundai Entourage Limited Minivan - Page 9 Questions & Answers
Entourage wont start until fourth or fifth try. no
no click? sounds like a faulty starter solenoid or loose connection. clean and retighten battery cables and connections to that solenoid. If that doesn't work, you may need to remove starter and have it tested.
Check Engine Light on
When a 'check engine light' (MIL=Malfunction Indicator Lamp) is turned on, there is a DTC (Diagnostic Trouble Code) set/stored in the ECM/PCM (Engine Control Module/Powertrain Control Module). This code identifies which engine management system component/function experienced a malfunction. Once you pull/read this code, we can possibly help. But until then, it's anybody's guess.
Firing order for 2007 hyundai
Hi, the firing order is often times stamped on the intake manifold. But my source has it as 1-4-5-6-3-2 for an even firing v6. I hope this helps!
I need to change the front right turn signal bulb
There are two 10mm bolts on top side and another one at its back side. However, removing these bolts isn't enough. You also have to remove a 10mm bolt at the front grill (on top, next to the headlamp assy) so the bumper/grill bezel can be moved a little to the side to allow you clearance to remove the headlamp assy.
Door lock on drivers side
If you haven't done it already, start with WD-40 or similar penetrating spray, and insert little red spray nozzle in the key slot and give it a spray, as well as the latch mechanism itself on door.When spraying latch mechanism, be sure to aim it up, down, behind etc as many directions as you can to make sure your getting all the linkages etc., in behind there the best you can. Wait a few minutes and repeat same procedure again just to be sure . Keep working the lock back and forth manually as well as with remote, to get it worked in and moving more freely. Once it's freed up and appears to be working better, Do same spray procedure with a lubricant such as, white lithium spray grease or similar to keep it lubricated. Make sure you apply some lubrication to other latches as well to eliminate same at them in future.
What is the proper way to bleed the brakes on a
to do a manual bleed first be sure to keep the reservoir full at all times during this procedure. start with the wheel furthest from the brake master cylinder. fill a small glass jar half full of fresh brake fluid. (don't ever use brake fluid that's been sitting around for any period of time with a broken seal on its container brake fluid is a hygroscopic fluid that actually absorbs water from the air even with the cap on the bottle it can be diluted making it less than useful.) find a flexible hose type straw that will fit on the bleeder head of your brake line tightly. step 1 ) stick the hose down into the jar submerging it in the fluid.( this is done so that when pressure is released the system doesn't **** in air which is what you trying to get out to begin with) step 2 ) have someone LIGHTLY( the brake system has pressure built up inside it and can shoot fluid many yards with excessive velocity this can cause damage to painted body parts or may cause bodily harm) press lightly on the brake pedal,step 3 ) you then slowly turn the bleeder screw until you see air or fluid coming out the end of your submerged hose,( the pedal should start to depress). when the pedal is pressed completely down have them hold it there, step 4 ) you then re-tighten the bleeder screw and have them release the pedal slowly.step 5 ) top off the brake fluid reservoir and repeat steps 1 through 5 until there is no longer air coming out, then tighten the bleeder screw down snug and move to the next closest wheel and do all again until all four wheels brakes have been bled. be sure to top off the reservoir when your done. i ope this helps
Not finding what you are looking for?