20 Most Recent
2007 Ford Explorer Eddie Bauer - Page 9 Questions & Answers
I have a 2007 ford explorer, all of a sudden, the
the blend door actuator is bad. there about 70 dollars at ford. make sure you hook up the actuator and put the control on defrost before you bolt it on the air box or you will brake the blend door.
7/19/2010 3:23:23 AM •
2007 Ford...
•
Answered
on Jul 19, 2010
How do you re-program the security code on a 2007
FORD KEY PADS
-
Enter permanent factory code
-
Press the 1/2 button within 5 seconds to enter
programming
mode
-
Within 5 seconds enter new code, doors will lock,
unlock
to verify code, this erases previous codes remotes will also need to be
programmed. (MAYBE)
KEY PADS/REMOTES
-
Insert key, turn ignition off-to- on eight times
in succession,
ending with key in on position doors will lock, unlock to verify in
programming
mode
-
Press any button on new remote, doors will lock,
unlock
to verify
-
Do the previous step with the second remote, doors
will
lock unlock to verify.
-
Turn ignition off. Doors will again lock, unlock
to verify.
NOTE-Some vehicles use 5 turns of the key instead of 8
6/7/2010 5:53:55 PM •
2007 Ford...
•
Answered
on Jun 07, 2010
I have a 2007 Limited Ford Explorer, 4.6 L V-8
Based on my experience...If you have the tranny fluid flushed/exchanged using a machine, like at a quicky lube type place...those machines show a measurement as the service is being done which represents flow...too low then change the filter as well. Not like the old days when the tranny pan had to be dropped to get fluid out, and other contaminants and therefore the filter was always changed as well. Hope this helps.
4/2/2010 2:55:51 PM •
2007 Ford...
•
Answered
on Apr 02, 2010
Who to change spark plug 98 ford explorer v8
The plugs are located under the coils on the engine. Remove the wire and screw from the coil and remove the coil and boot. Use compressed air to blow all of the dust/dirt out from the plug area. Removing the dirt is extreemly important. Remove th plugs and replace with a high quality plug. You may want to replace the boots also.
3/29/2010 4:14:44 AM •
2007 Ford...
•
Answered
on Mar 29, 2010
2007 FORD EXPLORER XLT
need to set tires at correct pressure you can find a sticker on the inside of drivers door to tell you the correct pressure after you do that it sould reset the light after you drive
2/2/2010 5:41:05 PM •
2007 Ford...
•
Answered
on Feb 02, 2010
Do not make revolutions over 3500 when is in park,
this is normal for new models over rpm without load is not good for the engine the knock sensor are controlling the rpm via engine computer.There shld be no problem regarding engine power when car is running.
1/12/2010 10:23:44 AM •
2007 Ford...
•
Answered
on Jan 12, 2010
I have a 2007 ford explorer. sometimes (not all
clean the throtle body remove the intake air housing from the air filter spray the throtle butterfly using carb or brake cleaner push the butterfly manually using a screwdriver remove the carbon buildup using clean cloth or tissue.
1/12/2010 10:16:59 AM •
2007 Ford...
•
Answered
on Jan 12, 2010
2007 ford expedition limitid
you mean change your keyless entry you need to call a dealership and talk to or drive to it and see the service manager and tell him your problem you will have to prove ownership of vehicle so they can give you a code
1/9/2010 10:57:52 AM •
2007 Ford...
•
Answered
on Jan 09, 2010
Not finding what you are looking for?