20 Most Recent
2008 Audi Q7 - Page 7 Questions & Answers
I HAVE HAD THE HEAD GASKET AND THE DRIVERS SIDE
Have you checked that the other side of the engine block isn't cracked? Have you pressure tested each cylinder to see where oil might be blowing by? Could be your cylinder rings are worn or there is a crack in your block elsewhere.
Reset oil change
You need to reset it with a scan tool at the dealership, or through an aftermarket scan tool like a
Vag-Com
Audi Q7 dies while driving
When motor will not turn over and you can hear the solenoid working and the battery is good check for dirty terminal at the positive lead.hey may look good but there will be a build up of lead sulphate ( Black crust) on the battery terminal and inside the lead terminal. Clean with sandpaper or file or proper post cleaner and try again . A simple check is to loosen the terminal and pressing down hard move the terminal back and forwards a few times to scratch the build up retighten and try starting
Hi
I have a 2007 Q7
Try to reset it as per MMI manual.The reset procedure is as follows:---
press SETUP, BIG KNOB and top right soft button together.Make sure you press them simultaneously. When done right, the MMI screen will go blank, then show the MMI booting logo and return to the menu finally.
Check fig below for which button to press:--
-------------------
This problem is also faced by many other users too.In there cases the MMI screen goes blank after car is parked in the sun for too long.The MMI starts working in their cases after the climate gets cold.So try this also.also try resetting by shutting car off, opening door closing door, and restarting the car--------------Check out this possibilities.This will help.Thanks.Helpmech.
.
Not finding what you are looking for?