20 Most Recent
2008 Audi Q7 - Page 4 Questions & Answers
Hello, can you tell me what alternative oil I can
All manufactures have a full synthetic,similar to Mobil 1. I use Mobil 1 and see no reason to switch,and I base that on pulling a couple oil pans that were very clean inside. If you want to save money,you will have to leave the full synthetic oils. The manufacture specs on the back of the bottle are whats important ,as well as the correct oil weight.
2/11/2010 11:30:00 PM •
2008 Audi Q7
•
Answered
on Feb 11, 2010
Driver side door wont open from outside
Fortunately, it means that the mechanicals of the door opening device are working right, if you can open from the inside. The rigid wire that connects the outside handle to the door opening mechanism became loose, or a plastic connector broke. Disassemble the door panel, reach the handle from the inside, and see if there is a thin rod dangling somewhere, and if not broken, just put it back in place.
1/10/2010 12:47:05 AM •
2008 Audi Q7
•
Answered
on Jan 10, 2010
Key stuck in door
Hi
Thank You for using
FixYa. There maybe a broken wafer in the lock or a
sharp cut on the key. Some dirt could be the problem too. Have you sprayed some
lubricant in the lock? If not then spray and check. You will have to take it to
an automotive locksmith or the dealer for repair. If you need to jump
start the car or recharge the battery use the remote posts that are situated to
the back right hand side of the engine space (the positive is under a red
plastic cap).
Please do accept the solution if
the issue is resolved or else revert for further assistance.
Thanks
Rylee
12/27/2009 12:47:45 AM •
2008 Audi Q7
•
Answered
on Dec 27, 2009
Removal of rear outter door handle
Ok
Remove plastic plug on the inside of door there is 10 mm hole use a hooked pick set pick put through the hole and pull the plastic cir clip towards the back of the door that will release the smaller part of the outer handle then the handle itself can be taken out.this is so simple but so deceiving the actual cir clip is hard to notice because of all the plastic **** on the inside backing plate the cir clip is just on the inside of hole look hard it is 2mm thick & 20mm high (black plastic) place point of pick in between backing plate & cir clip hook it and pull back the front door is based on the same principle but is a lot easier
7/16/2009 1:52:53 AM •
2008 Audi Q7
•
Answered
on Jul 16, 2009
Not finding what you are looking for?