Top 20 2008 Volkswagen Passat Sedan Questions & Answers

Check under the cover of each fuse box, detail is usually given on it.

Have dealer check the oil pressure with car running could be oil pump or pressure sensor

hi.at your pedal there sould be screws unscrew them to remove pedal the is a electrical plug you need to unplug also

From what?

If the check engine light is on then get the code read to know the exact cause!

Go to bing or google images and see if there's a picture of the fuse boxes.

engine coolant temperature sensor 2 circuit intermittent or erratic

You should ask , for example :hello i have passat 2008 my VIN is WVWZZZ....... i have problem on idle ? when the engine is warming up? when the engine is hot? when i accelerate ? ect... shaking means many things , i can help you but i need to know your Vehicle Identyfication Number wich is 17 letters and digits combination. www.tdiservice.pl

need more info, and correct terminology..

Check fuel filter.

faulty relay or ignition switch contact problem.i lean towards the contacts of the switch.

Have you had the engine computer checked for trouble codes ?

Hi. Are there any faults codes stored? Read the codes and repair accordingly.

Try a capacitive discharge, remove both battery terminals and hold them together for thirty seconds, if that fails check your fuses on the back of the radio. I’m happy to help further over the phone at https://www.6ya.com/expert/stephen_3312f315a96e2956

P0106 = Map sensor, it is out of range.P0172 = Fuel Trim it is too rich Go check out http://volkswagen-polo-highline.blogspot.com

Get the oil level checked,also it can be issue with clogged oil pump or faulty oil pump.Do ignore the indication,before it get worse.Check the help link mentioned below:-----Battery and Oil Warning Light Comes ON? http://technoanswers.blogspot.in/2012/06/2003-chrysler-pt-cruiser-battery-and.html---------Thanks.

What seems to be the problem with the car, other than the codes?

A device used to transmit power to a motor or component, without sending that high power through the switch itself, which would burn out the switch in a short time. The switch is used to energize the relay so the power can be transmitted through the relay to the component.A relay has two sides to it-the power side and the coil side. When the coil side is energized, say by the switch turning on, it causes the power side of the relay to connect the high power source to the wire going to the component or motor. Automakers use several relays throughout the car and its electrical circuits.

Insert the key and turn.

I found out what to do, there is a plastic covering on the door handle. Click that off and the use the key in the key fob to unlock the door. You can lock & unlock it.