Top 20
2008 Hyundai Elantra - Page 8 Questions & Answers
Fog lamp replacement on 2008 elantra
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front side cover screw.
3.
Remove the front fog lamp assembly connector (A).
4.
Remove the front fog lamp bulb (A).
Changing factory installed foglight bulbs on 2008 elntra
Your 2008 Elantra fog lamps are probably still under warranty. Take the vehicle into a Hyundai Service Center (dealership) or call the nearest one. Give them your vehicle VIN and ask them if the fog lamps are still under warranty. If they are, they will replace them for FREE!
How to remove brake bulbs
There are three mounting nuts on each lens assy which are accessed from the trunk behind the liner.
I need to remove the dash fascia
if you have a pocket on top of the dash take it off should have few phillips screws to remove. then just pull the plastic surround trim off. you will have to pull pretty hard especially if its new. then the radio will come it there are 4 screws holding it in.
Noise coming from front of car
It sounds exactly like a wheel bearing problem.The right side its seems would be the problem. When you turn right it puts more pressure on the bad bearing making it louder. I would suggest replacing both. If on is gone the other one isn't far off. Hope this helps
A random hazzard light
a service engine or check engine light. you have two choices either take it somewere to scan it for codes, or if it drives fine you can wait and see if the car does anything abnormal. if it runs fine for a while(week,month) you can reset the light by disconnecting both battery terminals from the battery . touch and hold the TERMINALS together for 10-15 seconds. MAKE SURE you do not touch the battery with the terminals. This will drain the remaining battery in the cables themselves and it clears the computer. Simply reconnect
2008 Hyundai Elantra
time for you to replace the remote control. common problem.
jj hyundai master tech boston ma.
Car Stereo
I HAVE A 2008 HYUNDAI ELANTRA. I HAD THIS PROBLEM WHEN I WANTED TO REPLACE MY FACTORY RADIO. I ENDED UP TAKING APART MOST OF MY DASH TRYING TO FIGURE IT OUT. AFTER ALL SAID AND DONE. I FOUND OUT THAT THE PIECE THAT GOES AROUND THE RADIO JUST SNAPS INTO PLACE. I USED A COUPLE OF FLAT HEAD SCREW DRIVERS TO PRY IT OFF. THAT IS IT. IT IS THAT EASY. THE WHOLE CAR JUST SNAPS TOGETHER. THE CAR IS CHEAPLY PUT TOGETHER.
What's does it mean when your P,R,N and D gears are blinking?
This usually indicates a problem with the transmission control module (TCM). You should have a qualified mechanic inspect and diagnose the problem, as it could be something as minor as a faulty TCM or something more serious such as a transmission failure. Replacement of the TCM or other components may be necessary to fix the issue.
All torque specs for 2012 hyundai elantra gls
a car.all cars made have service manual. every one.and all that is covered even a 3 inch think book.why not buy one from maker.or tell what country you are in .cars are not the same at all , in all countriessome have 5 or more engines choices and transmissions.check out Europe to learn that.nor did you say what is to be worked on, to torque.buy the book or if in USA read it here, at mitchell1 DIY online
https://eautorepair.net/Marketing/Default.aspbuy the book at the dealerpay on line or google all week long.
Not finding what you are looking for?