20 Most Recent 2004 Chrysler Town & Country Questions & Answers

contact parts store for code analisis may have a faulty computer..

there is a plastic cap where the arm connects to a post. pop this cap off with your finger nail or small screw driver. this cap hides a nut. remove the nut (10mm socket needed?) and pull the arm off to replace the blade

Did you try holding the gas pedal to the floor when starting ? It's getting too much fuel or not enough . Hooking up a scanner that can view sensor data parameters should be done to see which sensor is out of range . Coolant temp sensor possibly .

indicates a problem in the solenoid of the EGR valve ( short in the solenoid) take it to any service center for a check and replacement

Maybe, check the transmission fluid to see if the level is correct,it's usually pink, smell it, if it smells burned,or it's almost black, it needs changing, not sure that's the remedy, but it's a start.

code p 0440 refers to the EVAP system --purge valve malfunction check wiring and replace the purge valve

Try adding an extra earth lead from your battery to the engine block

Do a Google search with these words to find a belt guide. "Dayco Serpentine belt diagrams"

If the coil pack has a four wire connector, one wire is primary voltage, the other three wires are ground, one ground for each coil, one coil fires two spark plugs. If problem with coil or ground, you would lose spark for two spark plugs. Did you visually check for spark, everywhere? What about the spark plug wire or the spark plug, itself?

I would check all fuses regarding these , they make look intact but check the legs of fuses sometimes they get like a brownish coating on them that will cause them to play up, either wipe legs down with bit of sandpaper or replace with new. Hope you sort it.

Need to check all wiring regarding lights.

headlight switch or fuse

Oil Pressure Light Acting Oldly - CarGurus

www.cargurus.com > Questions > Chrysler > PT Cruiser

CarGurusApr 2, 2012 - As I continue to drive, the RPM needed to keep the oil light off (and therefore ... and when the light does turn on, I'm either at the other end of town from ... let it idle for 15min with the dummy light flashing? does the engine start ...

Oil light intermittent on off on at idle or when driving at - Fixya

www.fixya.com/cars/t25990585-oil_light_intermittent_off_idle_or_when

2 hours ago - Oil light intermittent on off on at idle or when driving at 2000Rpm, cause? Is the sending unit a possability? Seems - Chrysler 2004 Town ...

Recheck the wiring in the plug could have a short.

I have a 2009 gmc canyon how do I get to the wires

have you tried to move the nozzle in different positions to see if it helps. sometimes that`s all it is. also what makes you think its an EVAP problem with no testing done.