20 Most Recent 2007 Nissan Xterra Off Road - Page 8 Questions & Answers

Remove the firewall rubber grommet to the broken pipe in the firewall. Clean the remaining end of the broken pipe real good, apply a drop of oil on it, then push the heater hose back in and tighten the hose clamp back on. You will need a 12 point box end wrench and it will be slow due to limited access. It should work.

Window track is out of alignment. Tinker with it (if theres room for adjustment) and add some glass lube along the chanels

have a load test done on the battery to check for bad cell.

check the battery. have u tried a jump start? also check wire from battery to starter

No power at all is likely caused by a bad "fusable link." It could also be a bad negative or positive cable, but I'd get a repair manual (from library or auto parts store) to help you troubleshoot.

You are lucky they took it back. Did you use the proper wrench to install it and use the proper anti-seize lubrication? Check the wiring to it all the way that you can. IT would be best if you could check it all the way to the ECM. Do you remember what the code was?

Check wires at back of radio could of got a connection that has worked loose.

One of the wheel speed sensors is failing . A 'high end scanner' needs to be hooked up to monitor which one is glitching

On Nissan vehicles, the blower motor gets power from the fuse box, and the resistor and fan speed control provide the ground circuit. So you should be able to ground the motor and make it run if you have power going to it. Then you would need to check the resistor and fan switch. The high setting bypasses the resistor.

Here's a link Tim with pictures,just stroll down to see.Look's simple. Replace cooling fan clutch Nissan Xterra Forum

Something obviously left loose, have the work rechecked.

need a new clutch.