20 Most Recent
2007 Nissan Sentra 2.0 SL Sedan - Page 2 Questions & Answers
How to replace a serpentine belt on a nissan 2007 2.5 s altima
Video Tutorial: https://youtu.be/h4qGOJ5PpSw The easiest way to replace serpentine \ drive V belt on 2007-2012 Nissan Altima 2.5L 4 cylinders engine: - remove front wheel on passenger side - remove plastic splash cover - user 14mm offset wrench to turn belt auto-tensioner in clockwise direction - block auto-tensioner from moving using locking mechanism right above the auto-tensioner pulley - slide the belt off the smooth non-grooved water pump pulley first and then take the belt completely out - when installing a new serpentine belt, first hook it onto all pulleys except for water pump pulley. Hook it onto the water pump pulley last- make sure the new belt is hooked up properly onto all of the pulleys - unlock the auto-tensionerOriginal OEM Part #:
Amazon com OEM 11720 JA00B Nissan Altima Serpentine Belt Follow this diagram to route the new belt on 2.5L engine:
Help with learn mode.How to? sorry,it's a 2007 versa sl hatchback,not a sentra.
To activate a new transmitter in the tire pressure monitoring system WITHOUT the Nissan Consult scan tool: Under the dash above the OBD II connector is a single wire connector called the "tire pressure warning check connector". Use a jumper wire and ground the tire pressure warning check connector with the key OFF. Then turn the key ON and cycle the ground at the tire pressure warning check connector 5 times within 10 seconds of turning the key ON. This should cause the tire pressure monitor light to start flashing indicating the system is in "learn mode". Then use the activation tool starting at the left front tire and work around the vehicle in a clockwise direction - front left, front right, rear right and rear left. Activating each transmitter at each wheel should make the turn signal flash one time and after completing all 4 wheels, the turn signals should flash two times and all 4 time pressures should be displayed.
Why is my 2007 Nissan sentra 2.0 using 1 qt of oil every 600 miles?
More than likely u have a leaking valve cover gasket unless your seeing smoke than it might have a burnt valve guide or guides if its smoking real bad than it could have bad rings and you don't want that cause then u half to tear the motor down basically rebuilding the motor
Not finding what you are looking for?