20 Most Recent
2008 Chrysler Town & Country - Page 5 Questions & Answers
How to install tierod end ona 2008 town and country
undo the lock nut 1/2 turn. remove the ball nut and use a ball separator to get it out of the arm. take your new end and adjust the nut to the same position as the one you took off. screw it into the rod up to the nut then place the ball in the arm. If nothing has been moved then the ball will slip into place . If it dosen't then you will need an alignment when finished.
Rear overhead a/c controls
You should have a button on the front controls for the rear A/C that locks and unlocks the controls in the second row. Depending upon which A/C control system you have, it will either be a separate button or part of the temperature control button. It is marked with a padlock symbol. In either case,to lock or unlock the rear controls you push it.
Town country fuel odometer
When you fill up make sure that the car engine is stopped and keys are out of ignition, only stopping the engine but leaving the contact on or on accessories position will interfere with the car computer calculating the mileage base on the amount of fuel you pump.
Why is brake and ABS light on in town & country 2008
Highly likely that your vehicle may not stop next time you press on the brake pedal. Either the master cylinder is failing, the ABS module is failing, your brake servo is failing, or you have lost a significant amount of brake fluid due to a leak. IT IS URGENT THAT YOU GET THE VEHICLE TO A REPAIR SHOP IMMEDIATELY TO HAVE IT LOOKED AT. IT IS DANGEROUS TO DRIVE THE VEHICLE IT WHEN THOSE LIGHTS ARE ILLUMINATED SIMULTANEOUSLY.
Loose pins on Solenoid connector
Hi Mark, I'm glad to help! Mark, if in fact you do have loose pins and its not the Solenoid Pack itself. NOTE: Also if its not a transmission internal issue causing it, are an issue with the Solenoid Pack itself. You can check with the dealership and see if they have a wiring pigtail for the Solenoid Pack. I've never had to replace one here at the dealership but there's always a first time for everything. Hope this helps and have an awesome day Mark!
Power seat quit working
2002 town and coumntry 2002 town and country driver seat motor still runsyet seat wont move?. same with all other functions except back of seat button
A/c loosing freon after having heater core replaced.
They are in close proximity to one another.I would say if your AC worked just fine before going in and doesn't work now something happened during the work. They need to be notified sooner than later.They can evacuate the system and by using a dye figure out where the leak is at exactly.IF it is close to the work they did I would go after the dealer. good luck
Not finding what you are looking for?