20 Most Recent 2007 Mercedes-Benz ML350 - Page 9 Questions & Answers

If you mean that the brakes are hard to push but the pedal still only travels its normal distance then:
This is either a brake assist valve. A brake booster problem, or the vacuum line that feeds the brake booster.

If you mean it goes way to the floor before it stops you then you have a bad master cylinder or some air in a line.

I'll assume you don't have any warning lights on.

Hello and welcome to FixYa!
Do you have the portable type GPS? Hope to know more. I'll be glad to help you out. I'll be waiting for some more information.
Thank you.

i have a s350 from 2004 and i have a guestion.

Is it possible to replace an airmatic suspension by a normal suspension?
If it is possible are there any suggestions about which one?

pull out the radio and call the manufacturer and give them the serial number off the back of the radio and they will tell you the code.

The tall buildings in NYC make GPS very difficult. You must have direct line-of-sight to two or more satelites to make GPS work. Sometimes "reflections" from the buildings make it appear that you have signal but the reflections off of buildings will screw up your tracking by a few feet or a few blocks.

Good luck and sorry more help is not possible.

it's be all right for a week or two weeks don't worry but don't delay too long get it done as fast as you can.

Switch ignition on and immediately press the button to the bottom left of the speedo (trip reset type button) TWICE !!
Switch Ignition off
Press and hold same button while switching ignition on.
After 10 seconds a new interval will display followed by a beep.
Release the button and switch ignition off.
All done.

I think you need to post a little more information for someone to be of help. Cam Position Sensor and Crank Position Sensor problems are not uncommon on these cars (although you see more Crank Position Sensors go than Cam). Replacing them is not too difficult, if you have some mechanical skill. Just make sure your problem really is with the sensor before you start replacing parts. The sensors cost between $60 and $175 (depending on which and where you purchase it). If you have a specific code that you pulled from an ODB II reader, then start with that. If your check engine light is on, but you don't have an ODB II reader, then try your local parts store. Most will read codes for free.

just buy a new radio one with usb and SD card and bluetooth capabilities ,cheaper in the long run