2007 Chevrolet Tahoe - Answered Questions & Fixed issues

You have a faulty starter solenoid. It is part of the starter though. It may be a 'refurbished unit' which just means a clean and check over.

Yes your speaker are bad I bought a 2008 tahoe changed the radio out same problem no sound install after market speakers and problem solved

Check spark plugs for condition and gap. Clean Throttle Body and MAF. Make sure battery is fully charged. Check for codes and ECM data. https://www.google.com/search?q=2007+Chevy+Tahoe+is+having+trouble+starting ..

https://www.scosche.com/media/guides/ct1451.pdf

They are on the side of the engine block, there will either be a pipe plug or a sensor in the threaded hole(s)

there should be manual lever or circular selector that will fit your key into located on the rear door jamb with them open. There should be a lock or unlock symbol signifying which position is lock and which is unlock.

hi, sounds like you have a leak in your bladder, have to replace it in the seat.

I may have a simple fix. I have an 03 tahoe with the same problem. Somehow I found out that the compressor would kick on causing air to blow. When heating the truck up hit the compressor "snow" button and it would start using heat at 78 degrees. This may not work for all but it worked for me. I might be a a/c control panel problem. I hope this helps.

the p0300 code is misfire dectected on you engine. check for the misfire using scanner tools.

check fuse or connection

You should check out www.reliable-store.com they have info on repair, service, wiring diagram, electrical diagram, fuse diagram, troubleshooting, PCV, owner's/service/repair/parts manual, fault codes, error codes, etc everything on all vehicles. must check it out

Wiring, schematic, electrical diagrams, fuse diag, error codes etc are basic contents of these online books they sell here on this website www.reliable-store.com I have attached. Must check it out

Hi, the axle has a drain plug at the bottom, removing this plug allows all old fluid to empty, put the plug back in, and tighten. fill back up with 2-3 qts of 75 synthetic weigt oil. Good luck...Coop

There is not a fuse for just those lights. It controls the whole panel. The lights do have a history of burning out. They are easy enough to replace but pulling the instrument panel out. You can even get LED's for them now. There is a guy in Winnona Mn who has these along with the sync motors that always give trouble. To remove, pop the instrument panel trim - don't do at -20 four screws in corners take out. Pull out instrument panel - disconnect plug in the back. A couple of tabs hold it tight remove instrument panel Go inside and disassemble till you can see back of circuit board Remember to remove needles carefully - don't bend or break Un solder current light and solder in new ones Re-assembly in reverse Hope that helps - Also this guy in Winona MN will do it for you

The 4X4 system is controlled by a electronic control module . Can set a number of DTC'S - diagnostic trouble code's . Having the vehicle check for DTC'S would be your best bet ! Not at autozone or advance or any parts stores . They can not pull these code's . Need a factory or professional scanner . Your best bet , take it to a qualified repair shop.

it would appear so you never mentioned that at any time did they do a fault code reading and told you of the problem I would find an accredited service center and have the codes read to get a better idea of the fault . fixing by guessing is a costly exercise

I doubt it.The sensor could make the transmission not know when to shift, but not much else.

I think you have an intermittent electrical condition somewhere in ignition/start/run circuits.

Dealer . need factory scan tool to go into system an turn it off .

Check catalytic converter.