20 Most Recent 2007 Hyundai Accent GS Hatchback - Page 2 Questions & Answers

Chech all fuses first

should be 1.6L engine. easy to replace but is a belt not chain. unless you know how to line up camshaft / crankshaft, I'd pay for the labor. full kit on RockAuto.com is about $50 remove front right wheel, unbolt engine mount top passenger side, loosen accessory pump at top, remove timing belt covers (upper & lower), replace belt and idlers from kit. to reassemble....reverse steps. yes, it is that simple BUT not for a neophyte. inspect original belt before replacement, if no cracks, I'd leave alone. mine had 145,000 at replacement and was still good.

I suspect that your problem isn't in a fuse, it's in the brake light switch mounted up near the hinge point of the brake pedal, under the dashboard.

What about it? Its open? You can't open it? What do you need?

It could be a lot of things. These cars do however have a history of bad crankshaft sensors. Start there and also check the camshaft sensor. I would need much more detail about the problem to be any more helpful.

Hello Dan.

You did not mention whether you have a manual or auto trans.
There are two relays. One start relay and and one anti theft relay (if equipped).
If yours is auto equipped the switch is mounted where the shift cable is attached to the transmission.

I do however suspect you have the manual transmission as there is a service bulletin for a no crank problem. Here is the bulletin.

Group: CAMPAIGN
Number: 07-01-005
Date: FEBRUARY, 2007
Model:
TUCSON, TIBURON, ELANTRA, ACCENT Subject:
CLUTCH PEDAL IGNITION LOCK SWITCH REPLACEMENT (SERVICE CAMPAIGN T38) IMPORTANT: DEALERS MUST PERFORM THIS CAMPAIGN ON ALL AFFECTED VEHICLES PRIOR TO CUSTOMER RETAIL DELIVERY AND WHENEVER AN AFFECTED VEHICLE IS IN THE SHOP FOR ANY MAINTENANCE OR REPAIR. IMPORTANT: WHEN A VEHICLE ARRIVES AT THE SERVICE DEPARTMENT, ACCESS HYUNDAI MOTOR AMERICA'S "WARRANTY VEHICLE INFORMATION" SCREEN VIA DCS ON-LINE TO IDENTIFY OPEN CAMPAIGNS. DESCRIPTION: ^ This bulletin provides the procedure for clutch pedal ignition lock switch replacement. VEHICLES AFFECTED:
(EQUIPPED WITH MANUAL TRANSMISSION ONLY)

Also here is a basic wiring diagram.


Let me know here in comments if you need further assistance.

Thank you for using FixYa.

KL

the dealer sells the FSM. alldata.com

this refers to the fuel being to lean, there may be a leak in a air intake pipe or the air filter has become dislodged , check also for a fuel leak , check for a worn vacuum pipr , get your self a workshop manual will give you step by step guide's, also try a fuel addative , get one that covers the catalytic convertor as well as the valves etc keep me posted if you wish

I was told to check user manualGOOD LUCK

go to Hyundai dealer workshop they should steer you the right way or any car radio fitting workshops should be able to ether fix the problem or tell you how to to fix it.

remove obstacles first, you need to twist the bulb holder and then pull out.

check the wire in the window carefully to see if there is a break.. u can get repair kit at auto zone

check the contacks on the back window and the smoll elements in the glass if browken you can bay the slushon to vmend them