20 Most Recent
2007 GMC Yukon XL Denali - Page 5 Questions & Answers
My 2007 GMC Yukon Denali occasionally will not
{: ) I wonder how the cables were checked. Did it pass the 200mv voltage drop limit for the negative and positive cables? And do you happen to observe other disturbing symptoms while driving?
You can also try swapping your starter relay (at the underhood fujseblock) with a similar one, also check the relays corresponding terminals on the fuseblock for proper tension. The fuseblock terminals may have loose contacts withe the starter relay.
As for the warranty, it depends on your sales details witn your dealer. Normally a 2007 model is already out of warranty.
Hi, how do I remove
Most GMC and Chevys have a bottom plastic bracket holding the battery into the battery tray. All you need to do is get the correct socket and a wratchet with a long extension to loosen and remove the battery.
How do i change out the battery on my 2007 denali.
there is usually a small bolt that holds it in place with a rubber block the rubs along the bottom of the battery. Take a flash light and look for the small bolt at the base of the battery,,You need like a 1/4" drive socket with a 6-9" extention on the socket to reach it..Just unscrew the bolt and the bolt and the block will come loose,you just lift it up and out of the way. Remove old battery and reinstall new one in reverse order.
Our 2007 Yukon XL's third
try to look under it for the cheap *** piece of wire or spring they use to connect the lock levers to the handle.
The front and rear differentials on my 2007 Yukon
not unless you travel in extremely dusty/sandy roads. Most ppl dont change their fluids for the life of their suvs. If you drove thru deep water often i would also change it but the front and rears are sealed and synthetic fluids is man made and takes an extremely long time to break down.
Changing low beam bulbs? how, what do you have to
This is an easy fix that doesn't require any tools at all.
Raise the hood and look directly on the top of the headlamp assembly.
On each side, there's a rod. Swing it out and pull it up and out and place to the side for now.
Next, grab the assembly and pull it forward and you will see the bulb connections in the back.
Reverse the procedures to reinstall the assembly.
How do i replace the BCM of a 2007 yukon
If you replace the BCM on your own the vehicle will not start.The BCM has to be reconfigured per the RPO codes for your vehicle and per your vehicle identification number.This can only be done by a dealer.It takes a special scan tool and it has to hook up to a special computer at the dealership that has all that info for your vehicle and it reprograms the new Bcm.You can not use a used one because it will have the info from the vehicle that it came from.Hope this helps.Good luck.
Not finding what you are looking for?