20 Most Recent 2007 GMC Canyon Crew - Page 4 Questions & Answers

0helpful
1answer

My blend door will not open.

Either your actuator got stuck or has gone bad. Or your divider on the dash could be the problem. I would take it off the actuator before messing with the dash. And see if you can spin by hand or turn it. Unlock it and hope it is just stuck. Noemally I remove them then in my hand I connect the conector and turn the key on and turn my divider on the dash and see if it turns after I manually make it turn. If it works cool it could have been stuck. Good luck. 23732966-5oj0shduqnd3nognpvizeq0h-3-0.jpg
1/10/2015 2:44:19 AM • GMC Canyon Cars... • Answered on Jan 10, 2015
0helpful
1answer

My blend door will not function on my 2005 gmc canyon.

Looks like you might have to manually and disconnect the rod and turn it yourself or just unplug it and try to spin it by hand. If you cannot turn by hand then remove the bolts and turn it by hand then reinstall and see if it works. They do get stuck something or it just might be your switch climate divider on the dash. Good luck 23732972-5oj0shduqnd3nognpvizeq0h-4-0.jpg
1/10/2015 2:39:57 AM • GMC Canyon Cars... • Answered on Jan 10, 2015
0helpful
1answer

Locked out by antitheft on 2008 canyon

Antitheft or Security system failure is a common problem on GM vehicles. Every time you put your key in the ignition, the vehicle's security system reads the signal from your key to make sure it is OK to run. When it recieves the "correct key" signal, the security system allows the starter to turn over, and/or the fuel injectors to function and your car works like it normally does every day. If you were to use a different key, or try to hotwire it, the system would shut down these parts of your car, thus making the vehicle completely immobile. This is GM's way of preventing vehicle theft. The problem is that the system is known to fail quite commonly. It has been failing consistantly for around 30 years. When it fails, two things can happen. First, you turn the key and nothing happens at all. Lights work, radio works, windows work... just not the starter that you need to start the vehicle. This is a "starter immobilizor". Second, you turn the key and the vehicles starts just fine, but then stalls in 2-5 seconds. This is a "fuel immobilizor". It literally cuts off the fuel injectors and stalls the vehicle to immobilize it. These are normally followed by a light on the dash that says SECURITY or ANTITHEFT. These lights are to inform you of the system's failure to collect the information it needs from your key to the computer. If your security/antitheft light is on, odds are you will be stranded soon, if not already. There is a lot of info on this site that you can read up on. http://vatspasslockpasskeysecurityhelp.yolasite.com/
5/28/2014 1:04:14 PM • GMC Canyon Cars... • Answered on May 28, 2014
0helpful
1answer

Stalls and stops

Check your fuel pressure you could have a leak and your loosing pressure when you take your foot off the accelerate or peddle if it starts hard after stall suspect pressure regulator leak or bad vacuum or injection leak inside manifold
5/15/2014 10:39:43 PM • GMC Canyon Cars... • Answered on May 15, 2014
0helpful
1answer

Disconnected battery and now won't start locked out 2008 canyon

Turn ignition to on position for 10 minutes , do not crank it . Do this three times then turn key all the way off then your theft lock should be reset . Be sure to make sure battery is fully charged or hook battery charger on low to maintain battery while doing this process
4/22/2014 5:12:51 AM • GMC Canyon Cars... • Answered on Apr 22, 2014
0answers
0answers
0answers
0helpful
1answer

Car will start but will not go into gear

If the vehicle was running fine before, you've most likely got a transmission fluid leak. Start your car, put it in reverse then drive, then back to reverse and up to park. Leave the vehicle running. Pop the hood and check the transmission fluid, I'm sure you will find it's either low, or you've blown a pressure hose and lost all the fluid. I hope this helps.
11/2/2013 7:53:15 AM • GMC Canyon Cars... • Answered on Nov 02, 2013
0helpful
1answer

4wd lights are not on

!st of all, I really hope you are NOT driving on dry pavement with your 4x4 engaged. 2nd if you're trying to engage the 4x4 and your getting the service 4x4 light, it's telling you that it will not engage the 4x4. Hook up a code reader to your ECU and find out what's up. More than likely if you have the push button 4x4, your servo motor to engage the 4x4 is not working. If you're mechanically inclined buy a service manual and dig in, if not take it to the GM dealer before it becomes totally FUBARED
10/28/2013 4:02:40 PM • GMC Canyon Cars... • Answered on Oct 28, 2013
0helpful
1answer

I have a 2005 GMC Canyon that the Hazard flashes

replace switch. Try cleaning it with some electrical or brake cleaner first.
10/16/2013 4:48:22 AM • GMC Canyon Cars... • Answered on Oct 16, 2013
0answers

Code b2960

Be the first to answer 10/16/2013 4:03:12 AM • GMC Canyon Cars... • Posted on Oct 16, 2013Be the first to answer
0helpful
2answers

I have a 2005 gmc canyon. Occassionally it will

it's probably the transmission and u might have to change ur fuel pump also
8/23/2013 2:39:48 AM • GMC Canyon Cars... • Answered on Aug 23, 2013
0helpful
1answer

A/c doesnt blow any air

if no air blows at all,it is probably your blower motor.could be a blown fuse.your owners manual should tell you where the fuse box is,and which fuse runs the blower
8/7/2013 2:46:09 AM • GMC Canyon Cars... • Answered on Aug 07, 2013
Not finding what you are looking for?
2007 GMC Canyon Crew Logo

Popular Tags

69 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2005 GMC Canyon
2005 GMC Canyon

284 Questions

2004 GMC Canyon
2004 GMC Canyon

178 Questions

2006 GMC Canyon
2006 GMC Canyon

146 Questions

2009 GMC Canyon
2009 GMC Canyon

14 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Canyon GMC

  • Canyon GMC

Most Popular Question

2007 gmc canyon abs fault originally abs

  • Cars & Trucks
Loading...