20 Most Recent 2007 Subaru B9 Tribeca - Page 7 Questions & Answers

I went to the dealer and they showed me how to do it. Just pull it back, I thought it would break off----but it doesn't. Pull it back and it snaps right off.

We have an 05 Legacy and I've done this. Tribeca should be the same way: Look through the engine bay behind the light, you can locate the position by following the wires which actually connect to the bulb assembly. The bulb assembly ought to be removable with a 1/4-1/2 turn and pull motion. Be sure to not touch the replacement bulb with your bare hands. Your Subaru service ought to help you with this and not charge you......

Behind the engine on the power take off shaft housing. It has a blue cap on it.

First, check the following. I believe the 2001 Forester had a 3 position dome light switch. One position turned it on, one turned it off, and the third position enabled the light to come on when a door opened. Not all years had this type of switch. If yours does, check whether the light comes on for each and every door one at a time. If it fails for a particular door, you have narrowed the problem. If this problem always existed for your Forester, possibly the assembly was not properly done. If it is a new event and the dome light switch is in the proper position, there may be a short in the wiring. You would have to test the wiring with a multimeter. Perhaps this service manual will assist: https://servicingmanuals.com/manual/2001-subaru-forester-wiring-diagram/

'year make model' in all questions first 3 words please. I guess that is why no one took the question as it is impossible to answer. https://www.google.com/search?q=test+auto+relay all the fuse/relay diagrams are online https://www.google.com/search?q=year+make+model+fuse+and+relay+diagram ..

Haha, very good. I went to catering college in Birmingham and the station was near the Heinz factory. On Monday they cooked the tomato ketchup, you could smell it. Help in the link, but it doesn't sound like an easy fix. The part is $330. Check fluid, valves and solenoids first. https://www.google.com/search?q=1997+Subaru+Legacy+L%2C+automatic%2C+AWD+Transfer+Clutch+replacement ..

Needs to adjust shift lever cable or shift lever

if you have a large key ring, turn key to off or ACC and shake switch. if it goes off place switch and liten key ring

It would depend on what sort of noise.

Resetting the system after an ignition switch and key computer change in a 2009 Subaru Outback may involve several steps. Here are some general steps that you can try: **1. Check Fuses: Verify that all relevant fuses are intact. A blown fuse could be causing issues with the dash lights and fuel pump. Consult your vehicle's manual to locate the fuse box and check the appropriate fuses related to the dashboard and fuel pump. **2. Security System Reset: Sometimes, a change in the ignition system can trigger the vehicle's security system. Try resetting the security system by locking and unlocking the doors using the key fob. If your vehicle has an immobilizer system, make sure the new key is programmed correctly. **3. Battery Disconnect: Disconnect the vehicle's battery for about 15-30 minutes. This can help reset various systems in the car. After reconnecting the battery, start the car and check if the issues persist. **4. ECU (Engine Control Unit) Reset: If the engine control unit was replaced or modified, you may need to perform an ECU reset. This typically involves disconnecting the battery, turning on the ignition (without starting the engine) for a few seconds, turning it off, and then reconnecting the battery. **5. Reprogramming Keys: If new keys were added or the computer was changed, make sure that the new keys are programmed correctly to the vehicle's anti-theft system. Refer to your vehicle's manual or contact the dealership for guidance on key programming. **6. Consult a Professional: If the issues persist after attempting these steps, it's advisable to consult a professional mechanic or contact the Subaru dealership for assistance. They may have specialized tools and knowledge to diagnose and address issues related to the ignition system and key computer. Remember to exercise caution when working with electrical components in your vehicle, and if you're not comfortable performing these steps, seek assistance from a qualified mechanic or Subaru service center.

Time to fault find the headlamp wiring now then. Possibly a trapped wire maybe ......................

https://www.google.com/search?q=subaru+loyale+remove+fuel+pump+from+tank

In a single very short wrd, No. Replace the gasket and fix the overheating issue that caused the issue.

Try using a CD Lens Cleaner disc on it, but the link suggests it is a disc transport issue. That would need a Clarion Service Centre. Clarion make it branded as Macintosh. https://www.google.com/search?q=Subaru+Liberty+won%27t+read+CDs+Error+6 ..

no year car told. the now lost free users guide is by year.made 1994 to present (even 1989 as legacy outback)no country told at allsorry cars not the same world wide.open glove box, read the users guide? oops locked too>?most cars sold in USA , called wagonsopening the rear gate hatch by accident drivingkids fall the ground, or cargo hits cars behind you. (so is illegall that feature)and is never called a truck ever, in a wagononly on sedans. a hatch or 5th door it is named.In Europe then even call them 5 door cars.so I am confused.so all keys lost to the car. and can not drive it nor open any side doorsand rear hatch is locked and valuables in cargo area to fetch, right?I say call a locksmithand pick the lock.the door lock(mechanism) in the hatch internal, is accessed from the inside of the hatch open.so no why to attack it that way.call a locksmith,

https://www.fixya.com/cars/t26885563-2001_subaru_outback_fuel_cutoff_switch

bad wires replace them

https://www.engine-codes.com/p0420_subaru.html