20 Most Recent
2007 Chevrolet Chevrolet Silverado 1500 - Page 4 Questions & Answers
2014 chevrolet cruze 1.8l what can cause a coolant leak some where the thermostat housing?
there has been a recall on some year cruz about coolant leaks. Check with NHSTA.gov to see if you are included. If not you will have to replace housing hoses and any plastic connections around thermostat housing that carry coolant.
Chevy Cruze Antifreeze or coolant leaks typically appear in the thermostat housing of affected vehicles, though it can also leak from the recovery tank house or the throttle body heater inlet pipe in cars with 1.8L engines
Vehicle pulls hard to Right
limited information generic answer --check tires and rims [bent or damage balance ] brake caliper hanging up or flex line failure ---cv axle[s] ---steering rack --suspension bent worn
2002 Chevy Cavalier not getting 12 volts to the fuel pump only getting nine
Your better off finding the cause of the issue. Modern cars have so many sensors and electronics 'bypassing' electrics will become a Huge headache and put a massive dent in your bank account if it goes wrong!
Have you had the battery "Load Tested"? This is where they put a heavy voltage drain on it and see how it copes with it. How old is the battery? A battery can still hold 12 volt but be weak when it's got to supply power to high drain parts like the starter motor. Generally batteries are considered 'Old' when they are over 5 years old, especially on bigger and higher mileage engines.
The fuel pump relay should get power as soon as you turn the ignition to the second position so it can prime the fuel system before you start the engine. I've posted an answer to your Fuel pressure test question and in the video I've attached he shows you a quick "cheat" to test if it's the relay.
Torque specs for inner joint bolts to diff. 2004 chevrolet 2500 4x4 front axle
The torque specifications for the inner joint bolts that connect the front axle to the differential on a 2004 Chevrolet 2500 4x4 may vary slightly depending on the specific model and components used. However, I can provide you with some general torque guidelines.
Please note that it's essential to consult your vehicle's service manual or contact a qualified mechanic for the exact torque specifications, as they can vary depending on factors like the specific front axle design and any aftermarket modifications. Here's a rough estimate:
- Inner Joint to Differential Housing Bolts: Typically, the torque specification for these bolts is in the range of 85-100 lb-ft (115-135 Nm). However, it's crucial to verify the exact torque value from your vehicle's service manual.
Always use a reliable torque wrench to ensure that the specified torque is applied accurately, and follow proper tightening sequences and procedures as outlined in the service manual to prevent over-tightening or under-tightening, which can lead to problems with the front axle and differential.
Where is the cigarette lighter fuse for a Chevrolet City Express LT?
The cigarette lighter fuse for a Chevrolet City Express LT is located in the Engine Compartment Fuse Box. The location of the fuse box varies depending on the year of the vehicle. For instance, in 2003-2007 models, the cigar lighter (power outlet) fuses are numbered 29 (Auxiliary Power Outlets) and 30 (Cigarette Lighter). In 2008-2009 models, they are numbered 33 (Auxiliary Power Outlet) and 38 (Cigarette Lighter). In 2010-2022 models, they are numbered 25 (Auxiliary Power Outlet) and 73 (Cigarette Lighter).
Where is the fuel pressure regulator located on a 2014 Chevrolet Impala 4 cylinder
The 2014 Chevrolet Malibu with the L4-2.5L
engine does not have a 'typical' fuel pressure regulator. This vehicle has a fuel regulator valve (same function, just 'smarter' than a regulator). The pressure relief regulator valve replaces the typical fuel pressure regulator used on a mechanical returnless fuel system. Output drivers in the ECM provide the pump control circuit with a 12?V pulse-width modulated (PWM) signal, which regulates fuel pressure by closing and opening the control valve at specific times during pump strokes. On this vehicle, the regulator valve is built into and part of the high-pressure fuel pump. The high-pressure fuel pump is located on the rear, driver's side of the engine. For an image location view, click here:
https://bit.ly/3mgrSAv. Before replacement, make sure to inspect the electrical connector and wire harness for any loose, broken or damaged wires. And the rubber lines for any cracks, holes or disconnections
Not finding what you are looking for?