Top 20
2007 Chevrolet Chevrolet Equinox LT Questions & Answers
2010 equanox wont start no spark, no fuel, no starter. all fuses, relays, and and ignition switch are good
no car with A/T starts if it cant CRANK.
my stick car , push starts and gravity hill starts easy, too.
but not yours.
are head lamps dead, anything else dead, key on?
step 2 is (after key turn) is jumper cable starts.
ever do that, no, then call AAATOW>
or try to crank in NEtural as the operators guide tells how.
ok fuses good, we test them....
no cranks. 101 (i use a voltmeter and dont guess)
- battery just discharged or bad.
- battery lugs green with corrosion.
- battery cables all 4 ends loose, 1 or more.
- starter bad, if hotwire test fails now.
- starter ok hot wired, key line is dead.
- key line dead , PRNDL switch bad. or wire to it, (aka TRS )
- bad wires end to end, all this section,. key switch last.
if you read your cars starter schematic you can see all this.
its very simple system, unlike EFI.
got a meter?
Cooling fans not coming on in 2007 chevy equinox
The cooling fans are computer controlled, the engine temperature at which they are turned on is about 225-230F, the signal comes from the ECT sensor. The fans are controlled through a relay in the underhood fuse and relay power distribution box, the location of the fan relay is shown on a sticker on the bottom of the lid over the power distribution box. The fan system is tested by the computer when you run a fault code test with a code reader or a scanner. Do this and see if a fault code comes up. DO NOT OVERHEAT THIS ENGINE OR YOU WILL DO SERIOUS DAMAGE TO THE CYLINDER HEAD GASKETS RESULTING IN A HUGELY BIG REPAIR BILL. Get this repaired ASAP.
My 2006 chey equinox lx
engine light comes on and you speed up dont do that can damage vehicle---have trouble code read most auto stores offer this service for free --a flashing means misfire or problem that needs immediate attention
I need to find how to program a transponder key on a 2007 Chevrolet Equinox , VIN starts with a 2
This 30-minute learn procedure should be used when all vehicle keys are desired to be replaced or reprogrammed. This procedure will erase all previously learned vehicle keys from the TDM. Once the 30-minute learn procedure has been completed, any remaining vehicle keys may be programmed using the Adding Keys procedure to ensure their continued functionality.
- With an unlearned master vehicle key, turn ON the ignition, with the engine OFF.
- Observe the security indicator, after approximately 10 minutes the telltale will turn off.
- Turn OFF the ignition, and wait 5 seconds.
- Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.
Important: The TDM learns the key transponder information upon the ignition switch transition from OFF to ON. You must turn the ignition OFF before attempting to start the vehicle.
- With a master vehicle key, start the vehicle. The vehicle has now learned the key transponder information.
- If additional keys are required to be learned, refer to Adding Keys.
- With a scan tool, clear any DTCs.
License plate light out
Try using a trouble light to see if your getting current to the bulb socket. You may have a broken wire somewhere.
Not finding what you are looking for?