20 Most Recent
2012 Nissan Versa 1.6 S Sedan 1.6L 4-cyl. 5-speed Manual Questions & Answers
How do i bleed the clutch on a 2009 nissan versa
Well, you size the wrench needed for the bleed valve on the slave cylinder, mounted on the transmission housing 8 or 10 mm in most cases. Make sure the clutch reservoir is full, and kept full. Then you'll need a trusted assistant to work the pedal-one who will understand the reasoning and procedure behind bleeding a hydraulic system of air trapped inside the lines-it hinders hydraulic pressure on the clutch fork to make the clutch work at all. I say trusted because you dont wanna make it an unpleasant experience (I've participated in quite enough of those videos!) Patiently explain that the clutch pedal should be depressed slowly and steadily to the floor after you have opened the bleed valve and kept depressed to the floor until you have closed the valve. So just as the pedal starts traveling down, open the bleed valve, fluid is forced down through the line and out the open valve. Best if you close it just before the pedal reaches the floor-as soon as pressure is let off, air has a chance to re-enter through the open valve, so close it quick. A couple of times should do it-when you have a steady stream of fluid, no more air, and you know the line is bled of any possibility of air, then finish tighten the bleed valve, not too tight. Check the reservoir again, and take your trusted associate to dinner.
U1000
U1000 - CAN Communication Line Signal Malfunction
Causes:
- Harness or connectors (CAN communication line is open or shorted)
- Faulty Engine Control Module (ECM)
Solutions:
- Poor harness ground connection
There is a service bulletin for the following Nissan models with U1000 code:
2002-2006 Nissan Maxima
2004-2006 Nissan Titan
2004-2006 Nissan Armada
2002-2006 Nissan Sentra
2005-2006 Nissan Frontier
2002-2006 Nissan Altima
2005-2006 Nissan Xterra
2005-2006 Nissan Pathfinder
2004-2006 Nissan Quest
2003-2006 Nissan 350Z
2003-2006 Nissan Murano
The service bulletin suggest cleaning engine and body harness ground connection to repair problem.
How do i check the transmission fluid on nissan versa 2012
The dipstick is located in the hardest to reach spot. On the drivers side, under the battery, under a pipe or two you have to find a black dot, that dot is the dipstick. There is no ring or hook to grab it by so pull the black dot out and you'll see that it is about 2 inches long, the 'dipstick' itself is about the size of a thumbnail. We had to use two funnels slid together to be able to put the fluid into that hole. Then dropped the dipstick while trying to put it back in, multiple times. This was the most extremely frustrating routine maintenance I've ever done. I understand now why so many Nissan Versas have transmission problems, no one can maintain them properly. I've attached a photo of what the dipstick actually looks like.
How do I adjust the headlights for a 2013 Nissan Versa?
That is not easily done since these modern cars have large integrated plastic shells with the reflectors and lamps. The mounting points might have an adjustment, but if you do it wrong, you might break something. That could be very expensive. Gone are the days of metal brackets and screws holding heavy glass lamps that are almost indestructible.
There are specialized headlight aiming machines for many models that will let a technician accurately adjust your Nissan. Contact the dealer to see if they do it, or can refer you.
Wher is the AC relay on a versa 2011
The best solution you'll get from books at
www.reliable-store.com
These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc
Not finding what you are looking for?