2005 Volkswagen Sharan 1.8 - Answered Questions & Fixed issues

This is a very involved job which require you to remove the timing belt and the timing chain in the rear of the engine. I would not recommend you do this unless you know what you're doing.

try getting these checked faulty switch or wiring or couled be a relay sticking on the way to check if its the switch removing the harness fron the light switch wile the lights are on if they go off its the switch hope this helps ivan

You are possibly low on power steering fluid. Check the reservoir and top it up as needed. You will need to do this again after a short while, as air works its way out of the pipes.Then you should think about why it got low to start with. It is possible the power steering gear has sprung a leak somewhere. A common place for that is the steering rack end seals.

Just some info could be filter or fuel pump. copy and paste to google search. diesel which is takes some time to crank. https://www.youtube.com/watch?v=yRMTEAKsScE

OBD2 means "on board diagnostics generation 2"

run the fault codes and look for a problem reverse servo/solenoid or a problem TCM

Is this the diesel version or a petrol engine ?

sounds like the switch which is at the front middle of the gearbox easy to get too,unless its a auto which although i customer with a auto version i havent done any work to the gearbox apart from top it up with oil,i have a diesel ford galaxy manual which is the same but with a ford badge and its a lovely motor although the paint has faded with the sunlight here in spain .

HI Youssef i believe that when you put the volume up to the max, you blow up the main fuse, because the new radio with volume up to the max consume more amps than the fuse is set to for the original radio. now you have to look into the fuse boxes and replace the fuse, this will sort out the radio and the door lock problems as i hope. Good luck

how do i adjust steering pump belt 2006 skoda fabia?

06 sharan sprayed and cleaned egr whilst still on engine not much carburn checked pipes clear but thecar permites black smoke turbo kicks in when required but engine sounds as if the timing is out can you help does it need a new egr or turbo

Each Vehicle is Different, Open up your Owners Manual and the directions are in there or you VW Dealership and they can assist you best.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

if you bring it to most any big auto parts store they will scan it for free then post the code and we can lead you to a repair

google 2009 volkswagen jetta 2.5 fuse box diagram copy and paste https://www.autogenius.info/volkswagen-jetta-2003-2009-fuse-box-diagram/

Diagrams here https://www.google.com/search?q=2012+vw+jetta+s+2.0+serpentine+belt+diagram&safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk02XcbxGj-VkjbXjrQr8D0WTO0NtmA:1618711808742&source=lnms&tbm=isch&sa=X&ved=2ahUKEwi02umy24bwAhV-EVkFHZ6fB_MQ_AUoAXoECAEQAw&biw=1920&bih=937 ..

Question edited for clarity and toss in some CAPS. Question moved to Maker category. Check out the link and images. https://www.google.com/search?q=2013+VW+Caddy+panel+van+with+BSF+engine+torque+settings ..

'VW 19 tdi', isn't 'year make model' which is needed in all questions. 2019? 1.9? https://www.google.com/search?q=VW+19+tdi Likely to be anti-theft system or fuel delivery. Check for diagnostic trouble codes (DTC) using a pro grade scan tool computer. https://www.google.com/search?q=mobile+auto+electrician+near+me ..

To crank an engine means to turn it over with the starter motor. Is this what you mean ... it won't turn over?