20 Most Recent 2004 Volkswagen Polo 1.4 Questions & Answers


The crankcase is building up pressure. This should normally be drawn off through the PCV valve into the intake manifold, so, that valve has probably failed through fouling. Overhaul or replace it.
.

2004 Volkswagen... | Answered on Jun 25, 2018


For what?

2004 Volkswagen... | Answered on May 13, 2016


Get the repair manual for your specific car, far to much detail needed for a forum like this.

2004 Volkswagen... | Answered on May 07, 2016


The ABS system may cause a vehicle to go into limp mode if it is defective. Most times that will happen if your ABS light is lit up on your dash board!

2004 Volkswagen... | Answered on Sep 21, 2015


when compressors fail that is usually what happens they blow fuses .

2004 Volkswagen... | Answered on Sep 06, 2015


Go here, you may have to compare two of these to get the specs to come up but it will tell you the torque settings. http://automobilio.info/en/Volkswagen/Polo/?lng=en

2004 Volkswagen... | Answered on Sep 01, 2015


You have a major problem. Either the window regulator or the clips that hold the window on broke. My guess is the regulator because of the cable. To disassemble the door look for the screws holding the inner panel on remove them don't forget the one in the door pull and behind door handle. Carefully pry panel off remember there is some clips holding the panel on. Disconnect any wiring connection and carefully lift panel up towards top of door do not force. You will see a cover of some sort remove it. You are in door and should be able to see the problem

2004 Volkswagen... | Answered on Aug 18, 2015


Dude? If you tore into your engine to replace the cam timing belt then you must've had a manual ...right? Tell me you did. 'Cause if you did then that info should be in the manual. If you didn't ...well ...good luck.

If you got this far posting a question, try doing some online sleuthing to find out where the mark is.

2004 Volkswagen... | Answered on Apr 13, 2015


on inlet manifold or seprately on vac hose

2004 Volkswagen... | Answered on Mar 04, 2015


on the intake manifold, has a plug/wire coming out of it.

2004 Volkswagen... | Answered on Mar 04, 2015


Probably brake pads are worn and when turning the bearings have just enough slack to allow the pad wear indicators to scrape the rotors.

2004 Volkswagen... | Answered on Feb 19, 2015


switch ignition on but do not start engine, select reverse gear and then you can get out and have a look if it is working

2004 Volkswagen... | Answered on Jan 24, 2015

Not finding what you are looking for?
2004 Volkswagen Polo 1.4 Logo

Popular Tags

173 questions posted

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Polo Volkswagen

  • Polo Volkswagen

Most Popular Question

just done piston rings but now its

  • Cars & Trucks
Loading...