20 Most Recent 2004 Toyota Corolla Sedan Questions & Answers

Use some wheel bearing grease on the O-ring before you install it. Rotate the injector slightly as you push it in.

need to kill the mice or find a better place to park. even if you block this entrance they will not stop. I have seen whole electrical systems, vaccum sysyems. destroyed by mice. interior ect. get some poison and traps bated with chocolate. if you don't want to kill them find some traps and relocate them to a far away feild. if they are anywhere near your vehicle they will chew on anything and everything they can.

Check you cables, see if you have a short in the grounding cable. The end grounding it to the car may have come loose. Have you ever replaced the cables? That would be my next step before you dump money into it. You know it isn't the battery so just work from there.

Maybe something got stuck in there. Kids?The window track may be out of alignment.Pull the door panel to check the adjustment points.(3). Also,the motor may just be tired. Live in a cold climate where ice jams the window?

Question edited for clarity. Question moved to model category. https://www.google.com/search?q=Toyota+5afe+Main+bearing+torque+spec ..

Yes

Not good. https://www.google.com/search?q=TOYOTA+COROLLA+RUNX+cam+and+crank+sensors+have+no+power You need an auto-electrical specialist with a pro grade scan tool computer. https://www.google.com/search?q=mobile+auto+electrician+near+me ..

Question edited for clarity. All question need FULL 'year make model;' as first 3 words. Question moved to Toyota Corolla. There are over 40,000 categories to choose from listed by 'make year model'.

Car Shuts Off While Driving: 7 Reasons Why and What To Do

Car From Japan https://carfromjapan.com > Car Talk > Maintenance Tips Jun 13, 2023 - This happens when the engine is very sensitive at idle and can be caused by many things, but the most common reasons are a faulty throttle body ... The easiest way is to find a local auto electrician. A professional grade scan tool computer can diagnose the fault by recording what happens when it cuts out. https://www.google.com/search?q=auto+electrician+near+me ..

Toyota 7A-FE valve clearance (measured cold): - Inlet: 0.15 to 0.25 mm (0.006 to 0.010") - Exhaust: 0.25 to 0.35 mm (0.010 to 0.014") Source: https://workshop-manuals.com/toyota/corolla_sedan_4-door/l4-107.5_1762cc_1.8l_dohc_(7a-fe)/maintenance/tune-up_and_engine_performance_checks/valve_clearance/system_information/specifications/page_815/

Question edited for clarity. Question moved to model category. Engine immobilizer. https://www.google.com/search?q=mobile+auto+electrician+near+me ..

As advised by your mechanic, my advise is no different, in the gearbox there are what we term as teeth of different gears and synchronizers...being in such behaviour, your car needs a gearbox overhaul or replacement depending on which will cost you less

Question edited for a lot more clarity. Question moved to 'make and model' for the engine. No that is the last thing it is likely to be! It was working before, why would it fail because you changed the valves? Did you carefully lap the new valves with grinding paste to make sure they sealed? Are they all opening a closing. Is the gap correct? Can you do a compression test?

The 3 Most Common Toyota 1ZZ-FE Engine Problems

TuningPro https://tuningpro.co > the-3-most-common-toyota-1zz... Jun 21, 2021 - Power loss; Poor engine operation. Excess oil consumption is generally anything over 1 quart per 1,000 miles. As oil blows-by the piston rings ...

https://www.google.com/search?q=2e+engine+blows+oil+into+air+filter ..

have you removed the steering wheel cowling ? if not do this as may be another couple of screws there, if you have you have to gently wiggle it as far forward as you can so you can get your fingers behind it and release the speedo cable as it is usually this that is holding back these older car dash's

Sounds like piston blow by, as the gap increases and diesels have such high compression. When the turbo kicks in, the pressure is restored. https://www.google.com/search?q=Toyota+Corolla+2+Litre+diesel.+Why+loss+of+power+at+low+revs+when+warm ..

OK, so they do work, just not when using low beams. That indicates something to do with the headlight switch itself. It controls all lighting and could have an issue when low beams are turned on preventing the gauge/console lights from working. The switch is available aftermarket, I checked on one without fog lights on eBay and found one for around 33.00 shipped free. Pretty easy to replace, just remove the covers on the steering wheel and it's plug-n-play. Best of luck:)

When was the vehicles last full service ? have the OBD scanned for any fault codes also

For many of the 90's and 2000's Toyota various models - Camry, Tacoma, 4 Runners, Corolla, and some other models it is usually caused by temperature sensitive fan switch on the radiator not operating. Electric fan on the radiator should operate when temp above 200 degrees. Less often the control relay 90987-03003 is defective. Check if bubbling in the radiator smells like exhaust. That would indicate a blown head gasket. A jumper wire from your marker light positive to the lower contact in the fan control relay socket will operate your fan when parking lights are on. The larger vehicles with more powerful radiator fans will need a hefty jumper from a headlight positive to avoid overheating the lighting wiring.

Question edited for clarity. Question moved to model category. It appears to be a known issue on this diesel version. https://www.google.com/search?q=2007+Toyota+Corolla+d4d%2C+won%27t+start+after+replacing+glow+plugs ..