20 Most Recent
2009 Suzuki Grand Vitara Questions & Answers
Replacing antifreeze on a suzuki grand vitara 1.9 diesel 2009 model how is it done
Almost every car is the same. There will be a valve on the bottom of your radiator, if not (rare) you will have to take the bottom hose off. It is almost impossible to get all the old water out of an engine, so some people use a flush kit to run water through the system to get it clean. Then you will want to refill with a 50/50 water antifreeze solution. You have to keep in mind that if you flushed it with water then there will be a certain amount of water already in it. Thus add more antifreeze than water to make up for this. Also it is best to refill with distilled water to avoid any minerals that may be in your water supply. Make sure there are no air locks and top up after running the vehicle and allowing it to cool down.
How do I install fan cooling sensor grand vitara 2009
why do you think there is one"? NO SYMPTOMS POSTED !
most newer cars, use the cars engine, normal thermometer called
the ECT and is pure software the fan controls via relays
do you need a schematic?
alldata.com has it
as does suzukipitstop. (google those)
3.2L --V6 engine?, always post engine, or answers will be wrong.
or the 2.4L? engine?
09 GV
the fan or fans can be controls in stages, and with this magic software can even change the rules with A/C on, and does.
if there are symptoms , post them. ask for TESTS.
avoid Gue$$ing
ill quote the FSM now to prove my case.
ECT Sensor Strategy
The ECT Sensor provides a linear input signal to the Engine Control Module (ECM) for a number of engine control system calculations. The ECT signal is compared with Manifold Absolute Pressure (MAP), Mass Air Flow (MAF), Intake Air Temperature (IAT), and Fuel Trim (HO2S) in order to determine the correct air-fuel mixture for measured operating conditions. In some cases the ECT Sensor input is used in concert with the A/C Pressure (ACP) Sensor input in order to determine cooling fan and A/C system operation.
end quote.
My exhaust blows white smoke when excelerating
hi, this is a problem i have seen before, the result of brake fluid entering the intake maniflod via the brake booster vacuum valve. the cause is leaking seals in the brake booster. to check for brake fluid in the booster chamber, remove the vacuum hose, dip a slim wire or other into the bottom of the chamber and check for brake fluid on the wire. a booster overhaul is required to fix this.
Not finding what you are looking for?
