20 Most Recent 2005 Subaru Forester 2.5 Questions & Answers

Ckeck your govenator .

Not good. Its very likely that you have bent some valves on one or both heads. Get a new belt and pulley kit, and install it. By hand, rotate the engine to ensure that NOTHING is jammed. Take the plugs out and do a compression test. If the readings are normal, put the plugs back and start. If not, pull nor or more heads, get them reconditioned nada install new head gaskets.

is the Check Engine Light on? many newer cars will illuminate several lights and disable systems if the ECU records a DTC.

160,000 km major service. Anything over 150,000, think about getting it done, There's a set of bearing and the hydraulic tensioner (sometimes water pump) as well that should be done at the same time.

probably moisture in cap

there are many bushings that can wear out and cause squeeks. if you suspect this sound is in the front check your front sway bar links

check the seals in your door and the door frame.

check the bushes .

there is it should be located on the back of radio itself. if that doesn't work you may need to check your fuses

Please have a fuel pressure leak down test performed, most likely the check valve in the fuel pump has failed. A special tool and skills are needed top run this test.

Is the battery deadAlternator not chargingFuel pump failCheck for codes

Is there a check engine light on? I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

I suspect that the tire is old and the steel belts are failing. Pull the wheel off and check the tire for cracks in the tread, any out of round or bulges. Get a new tire (or tires).

those are not codes those show that you didnt read instructions completely on the use of your scan tool those show that their are codes present depending on unit you either hit next or codes or enter rescan vehicle and continue to next page when those show up

No - bleeding can be done well statically. Use a bleed tool to help get it right. After complete - check vacuum lines to master cylinder for cracks or leaks.