20 Most Recent 2006 Nissan Quest 3.5 Questions & Answers

Intermittin Engine Stall Engine No StartMissfire MISFIRE IN motor cylinder is more likely the cause to engine stall and hard start.You will have to fix this problem first, A misfire, most the time, is caused by, incorrect cylinder firing order (diagram at bottom). Or no or low cylinder compressionno or low compression is the result of A Vacumm leak.If the timing chain was recently replaced, the valve cover had to be removed, the valve cover gasket could cause a huge vacumm leak which would effect some if not all 6 cylinders,SymptomsLack/loss of power Hard start Engine hesitationFor Now check firing order( coil pack to sparkplug)check sparkplugsNISSAN 3.5 V-6 FIRING ORDERSPARK PLUG GAP 0.050'' SPARK PLUG TORQUECOIL PACK LAYOUTI hope this helps for nowIf you have any questions, you can email or post [email protected]

Start diagnosis at engine fan relays, A/C fan relays, any fuses or breakers, in main power supply, and at fuse box or boxes. Some cars have more than one fuse box, Inside and in engine compartment.

Possibly 1. Engine Control Module (ECM) may be faulty, harness ground circuit is open or shorted or harness power supply circuit is open or shorted (broken). Good Luck Mai

just replae right converter takes about 2 hours out the bottom thru the rh wheel openinng

2001 clock spring will not fit 2006 quest. totally different animals.

Have you never had any vehicle to a repair shop?Tune-ups are a term used for no apparent reasonThe vehicles computers have been tuning vehicles for over 30 yearsYou only have spark plugs left from that eraPrices are never avail over the internetYou ask those questions at a merchant of yourchoiceThere is no set priceYou don't know what needs to be done orwhat you want to authorize

To check first,reset see what happen[save code #]and fix the problem.

There is nothing in the wiring diagram that would cause the pump not to run because of a wreck. The pump is powered by a relay and a fuse, the relay is activated by the computer.If the pump relay is not getting a ground signal from the computer the computer may have to be flashed with a scanner.