2005 Nissan Almera Tino - Page 2 - Answered Questions & Fixed issues
I'm asking for Engine torque settings of Nissan almera 1.6 model of 2002.
you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
Nissan almera tino passenger electric window not working
Need to pull remove the door panel. Test the motor if its bad then replace it. If its working then can. Check fuses, switches, wires and grounds. Could be several things. Could be the window regulator is broken also which would be to replace that is the option. How much do you know about electrical things volt meters and connecting two wires to motors to test things. Check youtube for videos
Injector pump gave trouble on nissan almera so i
Not the EGR. Pump is definitely out of time and too much fuel makes it smoke like that and you lose power because the engine is flooding with fuel and it just cant burn it quick enough. Makes sense, huh.
Crunching noise from front left side of 07 almera
Can you share more detail information about this noise ? How often does it happen ? When does it happen (turning) ? The more details you add, the better we can assist you with your possible problem.
My almera 1.6 2004 model coils not recieving power.
ok, i will try and help you as much as i can. first you should be getting 12 volts a pulse and a ground( negative ). if you're getting the 12 volts and the grounds but no pulse the the car has 2 sensors, one is the cam and the other is the crank. those sensors provide pulse to one for the injectors and the crank is for the coil packs. you can test for pulse by using a noid light or the normal test light. just connect the test light to 12 volts terminal and have someone crank over the engine. if you don't get a low flickering light then you neeed to change the sensor
Why doesn't it start?
you really should have removed throttle body to clean properly. The fuel intake system is probably full of the cleaner and other crud now and you might get it started by holding pedal to the floor, while cranking.
press the helpful button.
2001 1.5l. Why can't timing chain be replaced without dropping sump?
Most vehicles with timing chains have a cover over the chain that it attached to the oil pan. There are gaskets that have to be replaced between the two and removal of the pan is recommended to do this properly. Trying to avoid it can result in a number of issues, from gasket material falling into the sump to oil leaks from not having the lower part of the cover sealed properly.
Can the immobilizer or central locking be switched off in a Nissan Almeria 2001 car?
you can remove the central locking fuse , this will stop the lock/unlock constantly , the problem is usually with the drivers door lock mechanism , that is perhaps why you cant lock/unlock with the key, lock from inside vehicle and get out passenger side, that lock should work with the key until you get the lock changed on drivers door
Nissan almera 2002 was running fine stood over night now wont start
Does it crank over If no, then try jumping it from another car.
If yes it cranks but doesn't fire up, try spraying a small squirt of starting fluid into the air intake. If it fires up then dies it is a fuel problem. Very likely low on fuel or fuel pump circuit.
If it cranks but doesn't start with starting fluid there is a problem in the ignition-spark system.
Not finding what you are looking for?