Top 20
2005 Nissan Almera Tino - Page 6 Questions & Answers
2007 Nissan Armada Where is the TMC located at?
Are you looking for the location of the TCM (Transmission Control Module)?If so, you'll have to remove the transmission's valve body in order to access the TCM. You get to it by first removing the transmission fluid pan.
Which fuse controls the car door locks on a Nissan versa 2018
The specific fuse responsible for controlling the car door locks in a Nissan Versa 2018 can vary depending on the vehicle's configuration and model. In the Nissan Versa, the fuse box is typically located in the engine compartment or under the dashboard. The fuse box cover or owner's manual should have a diagram indicating the fuse positions and their corresponding functions. Look for a fuse labeled "Door Locks," "Power Locks," or similar. If you are unable to locate the specific fuse, consulting the vehicle's owner's manual or seeking assistance from a Nissan dealership or automotive professional is advisable.
2009 nissan x trail RH indcater does not work, all globe's are good. Any ideas to help?
If the 2009 Nissan X-Trail right turn signal is not working even though the bulb is good, there are several possible things you can check:
Check the fuse: There should be a fuse box in your car. Refer to your car's manual to find the fuse related to the turn signal. If the fuse is blown, replace it with a fuse of the same amperage.
Check the four-phase speed: The relay indicator may be defective. You can refer to your car's manual to locate the switch and replace it if necessary.
Check the turn signal: The problem may be with the stalk or the turn signal. If the switch is faulty, it may not send the proper signal to the indicator circuit.
Check the wiring: There may be a break or short in the wiring between the switch and the light source. This will require careful examination of the wiring.
Contact a professional technician: If you cannot diagnose or fix the problem yourself, it is best to take your vehicle to a qualified technician. They have the skills and tools to properly diagnose electrical problems.
Remember that working on a car's electrical system can be complicated, so if you are not comfortable or experienced in car repair, it is always best to seek help from a professional to avoid problems. accident or other damage.
How do i fix the oil and gas gauge on a 2006 nissan armada le
To fix the oil gauge on your 2006 Nissan Armada LE, you may need to replace the oil pressure sensor. According to a post on the Nissan Armada & Infiniti QX56 Forums, a high oil pressure reading on the gauge could be due to a faulty sensor. You can try replacing the sensor by following these steps:
Remove the wire connected to the oil pressure sensor.
Unscrew the old sensor and remove it.
Install the new sensor and reconnect the wire.
If this does not solve the problem, you may need to replace the oil gauge in the dash .
As for the gas gauge, it could be due to a faulty fuel level sensor. According to It Still Runs, you can try replacing the fuel level sensor by following these steps:
Pry off the rubber gasket from around your fuel and temp gauges on your dash with a flat-head screwdriver.
Withdraw the gauges from the dash and disconnect the wires.
Rub a pencil eraser on both ends of the electrical connections to clean any corrosion from them.
Install a new fuel level sensor and reconnect the wires.
If this does not solve the problem, you may need to replace the gas gauge in the dash.
Not finding what you are looking for?