20 Most Recent
2005 Nissan Almera Tino - Page 9 Questions & Answers
HOW TO TAKE OUT NISSAN 1400 2007 PICK UP
STEERING BOX. DO I NEED TO TAKE OUT ENGINE
Taking out the steering box in a Nissan 1400 2007 pickup truck involves a few steps, and you do not need to remove the engine to access the steering box. Here is a general guide on how to remove the steering box:
1. **Disconnect the battery**: Always disconnect the battery before working on any components in the engine bay.
2. **Raise the front of the vehicle**: Use a jack to lift the front of the vehicle and secure it with jack stands for safety.
3. **Remove the wheels**: Take off the front wheels to access the steering components.
4. **Disconnect the steering column**: Inside the cabin, detach the steering column from the steering box.
5. **Disconnect the tie rod ends**: Remove the tie rod ends connected to the steering box.
6. **Remove the steering box mounting bolts**: Locate and remove the mounting bolts that hold the steering box in place
2006 Nissan Xterra Security Issue
Is the security light lit up on the dash at all?What happens if you try to start the vehicle without unlocking the driver door with the key?Lastly, have you ever replaced the battery on your key fob? When their batteries get low, they can cause various problems that resemble mechanical faults or security problems.
My partners 2009 Nissan Navara wont start. It makes a clicking sound but just wont start. It also has recently started overheating.
The car does have alot of km's 399,000km's.
If the battery is OK the next thing to check is the starter motor itself. It usually shows as a single click or lots of fast clicks?
For the overheating, how long after you start the engine does it start to overheat? If it takes a while, usually as the engine starts to get up to working temperature, the first thing to check is the thermostat. This is the most common thing to fail especially on higher mileage engines. Do this first as it's the cheapest fix.
Next check the serpentine/Auxillary belt. A worn or damaged belt can slip slowing the pump down. This can also show as battery charging issues.
Another cause of overheating is the waterpump failing. This can commonly be heard as a whine, chirp, or a squealing noise especially on a cold start. It can also often, but not always, be see below the pump as staining from it leaking.
Dashboard lights on my 2017 nissan rogue do not turn on
Check the dimmer switch to ensure it's not turned down. If the dimmer is fine, check the fuse for the dashboard lights. If the fuse is blown, replace it. If the issue persists, it may require professional diagnosis for a potential electrical problem or a malfunctioning instrument cluster.
Why is my 02 nissan xterra supercharger 3.3 v6 is not running any better after I change crankshaft position sensor
The crankshaft position sensor's function is to let the PCM know the crankshaft's position, so fuel, spark timing etc can be fine tuned, based on engine load and driving conditions.
Some vehicles cannot start with a faulty or failed CPS, while others can but will have poor drivability.
Did you change your CPS because it was confirmed to be faulty or did you change it to improve the engine's running conditions? Did you pull any OBDII codes that pointed to the CPS circuit, before replacing it?
Chance are the CPS wasn't the cause of the issues you had.
Where is the inertia switch on a nissan maxima 2000
There isn't one. Easiest way to diagnose the fuel system is at the fuel pump relay. Make sure there is a good 12v supply and solid ground at the relay. Insert a jumper wire across the load side of the relay which would provide the pump a constant 12v supply. If it doesn't run, it's time to drop down the tank and see if you have 12v to the pump. If so, it's probably time for a new pump
Not finding what you are looking for?