20 Most Recent 2005 Nissan Almera 1.8 - Page 9 Questions & Answers

0helpful
2answers

I have yellow engine warning light on 2003 nissan

I have not used my nissan micra 2003 for 7 months it has been stored in the garage but the engine has been started on a weekly basis but today the warning engine light has come on, the car has only done 2300 miles, SHOULD I BE WORRIED or is it because the battery has been disconnected in between starting the engine so it didnt drain the battery while it was standing in the garage unused, this has happened the day before i take it for a mot.....
5/30/2011 12:33:14 PM • Nissan Almera... • Answered on May 30, 2011
0helpful
1answer

Could I got my code radio for my nissan pp2787h rds/eon cy54d

I need code for this serial, same radio, Thanks PP2787HB 0091600
4/18/2024 1:11:10 PM • Nissan Cars &... • Answered 8 hours ago
0helpful
1answer

I need the distributor cap firing order to the spark plugs for a nissan elgrand with a vg33e engin 1999 model

The firing order for the Nissan Elgrand equipped with the VG33E engine (1999 model) is 1-3-4-2, starting from the front. Nissan 3.3L (199 cu in) firing order - diagram & guide ' REREV
4/12/2024 10:26:20 AM • Nissan Cars &... • Answered on Apr 12, 2024
0helpful
1answer

Nissan langley exa wont idle

It could be numerous problems - consult a reputable shop - you need someone that knows what they are talking about to physically look at the car to solve the problem - will save you a lot of time and expense. ????
4/11/2024 10:17:51 PM • Nissan Cars &... • Answered on Apr 11, 2024
0helpful
1answer

Fan control problems on nissan np200. Controls only work on maximum not on the the lower levels of fan control. Help?

Probably the fan got blocked with some debris and caused it to draw too much power, that caused the fan controller to fail. Or, the fan controller has failed, has a bad connection etc. Check the cabin filter if it has one, for a blockage.
4/8/2024 3:13:30 PM • Nissan Cars &... • Answered on Apr 08, 2024
0helpful
1answer

Hi NISSAN PRIMERA P12 2002 D SVE 18 MARCH 2024

Hello, Malcolm. It seems like you are facing an issue with the alarm system of your Nissan Primera P12 from 2002. Based on the symptoms you've described, it does sound like there might be a fault with the alarm system or the central locking mechanism. Given that you have already tried a few troubleshooting steps such as disconnecting the battery and replacing the micro switches, it might be a good idea to further investigate the alarm system itself. Since the hazard lights are flashing without any audible alarm sound and the central locking is behaving inconsistently, there could be a fault in the alarm control unit or wiring. One possible cause could be a faulty alarm module or a loose connection in the wiring harness related to the alarm system. It's also worth checking the condition of the alarm siren to ensure it is functioning properly. Considering that the issue seems to have improved after disconnecting and reconnecting the battery, it's possible that there is an intermittent fault related to the power supply or a reset of the alarm system. If the problem persists, it might be best to consult with a professional mechanic or an auto electrician who can perform a more in-depth diagnostic test on the alarm system to pinpoint the exact cause of the issue. In the meantime, if you experience the hazard lights flashing again, try to document when and under what circumstances it occurs. This information can be helpful in diagnosing the problem more accurately. I hope this information helps, and I wish you the best of luck in resolving the issue with your Nissan Primera P12. Feel free to reach out if you need further assistance or have any more questions.
4/8/2024 6:44:59 AM • Nissan Cars &... • Answered on Apr 08, 2024
0helpful
1answer

How to remove starter motor 1994 Nissan Bluebird SSS 2litre Attesa- U13 Engine AWD-Petrol and I also really need your help to find a repair manual for the car thank so much!

To remove the starter motor on a 1994 Nissan Bluebird SSS 2 litre ATTESA-U13 engine (AWD), follow these steps: 1. Disconnect the negative terminal of the battery to prevent any electrical accidents. 2. Locate the starter motor, which is typically located near the transmission bell housing on the engine block. 3. Remove any heat shields or other components that may obstruct access to the starter motor. 4. Disconnect the electrical connections to the starter motor, including the wiring harness and solenoid. 5. Remove the mounting bolts that secure the starter motor to the engine block. 6. Carefully slide the starter motor out of its mounting position and set it aside. 7. Install the new starter motor by reversing the removal steps. As for finding a repair manual for your Nissan Bluebird SSS, you can try searching online for a digital version that you can download, or you can purchase a physical copy from a reputable auto parts store or online retailer. Additionally, you may also be able to find helpful information and step-by-step guides on online forums and websites dedicated to Nissan vehicles.
4/8/2024 6:34:37 AM • Nissan Cars &... • Answered on Apr 08, 2024
0helpful
1answer

2018 Nissan NP200 8v. Throttle body problem as it's hunting when starting. It also doesn't have the same power as before. What can I do?

Has the Throttle body been removed and cleaned thoroughly both sides? Was a Throttle body relearn done afterwards. https://www.google.com/search?q=2018+Nissan+NP200+8v.+Throttle+body+problem Ideally you need an auto electrician to check for Diagnostic Trouble Codes and do a full system scan with a pro grade scan tool computer. It can also do the relearn and check the IAC. https://www.google.com/search?q=auto+electrician+near+me ....
4/6/2024 3:07:08 AM • Nissan Cars &... • Answered on Apr 06, 2024
0helpful
1answer

1996 Nissan Largo. I just purchased it and the heat does not work. We thought it was the control valve and replaced it, flushed the heater core as well and still nothing.

Question edited and turned around for clarity. Not enough coolant in the heater core. Have a read and follow these instructions carefully. https://www.fixya.com/support/r29872074-vehicle_cooling_system_no_heat They do have some 'history'. https://www.google.com/search?q=1996+Nissan+Largo+no+heat ..
4/5/2024 4:00:55 AM • Nissan Cars &... • Answered on Apr 05, 2024
0helpful
1answer

My Nissan NP200 (16v) 2011 model revvs high at idle,when engine is cold, and hunts quite badly till engine gets to operating temp. This sometimes even happens after engine gets warm. Please advise.

Is this electronic throttle control ? Try cleaning the throttle plate with some carburetor cleaner , they can get dirty an cause this problem . Are any lights lit on your dash , check engine , ETC , ? This is a 2011 ? Still under warranty , take to the dealer !!!!
4/4/2024 5:21:23 PM • Nissan Cars &... • Answered on Apr 04, 2024
0helpful
1answer

IM having trouble with my nissan narva d22

Is this a new key as well? On a lot of modern vehicles the vehicle's electronics need to be told that there is a new ignition key and ignition barrel fitted. This will need to be done through the OBD connector under the dashboard. If it is not done the vehicle immobiliser won't turn off as it doesn't recognise the key you are using.
4/3/2024 7:17:17 PM • Nissan Cars &... • Answered on Apr 03, 2024
0helpful
1answer

1997 Nissan Terrano 2.7 - changed battery. - won't start - but turning over

You will probably have to reset the ECU as it thinks the vehicle may be stolen and shuts the fuel supply off. I always plug a motorbike battery with a cigar lighter plug on it, to keep the electronics live whist changing the battery. It keeps 12volts on the system and avoids this sort of thing from happening.
3/29/2024 8:22:53 AM • Nissan Cars &... • Answered on Mar 29, 2024
0helpful
1answer

EXPERIENCING A CODE HO2S12 AFTER REPLACING BOTH O2 SENSORS ON MY 2014 NISSAN ALTIMA , High voltage to bank 1 sensor ....

I would check the heaters are working on the down stream sensor and ensure they are supplied and manufactured by Nissa.
3/25/2024 6:53:03 PM • Nissan Cars &... • Answered on Mar 25, 2024
0helpful
1answer

HOW TO TAKE OUT NISSAN 1400 2007 PICK UP STEERING BOX. DO I NEED TO TAKE OUT ENGINE

Taking out the steering box in a Nissan 1400 2007 pickup truck involves a few steps, and you do not need to remove the engine to access the steering box. Here is a general guide on how to remove the steering box:
1. **Disconnect the battery**: Always disconnect the battery before working on any components in the engine bay.
2. **Raise the front of the vehicle**: Use a jack to lift the front of the vehicle and secure it with jack stands for safety.
3. **Remove the wheels**: Take off the front wheels to access the steering components.
4. **Disconnect the steering column**: Inside the cabin, detach the steering column from the steering box.
5. **Disconnect the tie rod ends**: Remove the tie rod ends connected to the steering box.
6. **Remove the steering box mounting bolts**: Locate and remove the mounting bolts that hold the steering box in place
3/22/2024 4:01:07 PM • Nissan Cars &... • Answered on Mar 22, 2024
0helpful
1answer

2019 Nissan Rogue. Key fob programming.

This says it needs a programming computer, so Auto-electrician, Auto-Locksmith or dealership.

2019 Nissan Rogue Keyless Entry Remote Fob Smart Key ...

programyourremote.com https://www.programyourremote.com > classified > 2019... Step by Step How to Programming Instructions: This vehicle is not on board programmable and requires a qualified professional to program smart key remote fobs. https://www.google.com/search?q=2019+Nissan+Rogue.+Key+fob+programming ..
3/21/2024 10:00:08 PM • Nissan Cars &... • Answered on Mar 21, 2024
0helpful
1answer

2009 NISSAN ROUGE REPLACED VALVE BODY BUT NOW NO REVERSE

https://www.justanswer.com/nissan/jzqy5-replaced-valve-body-no-reverse-its-hot.html
3/21/2024 2:25:40 PM • Nissan Cars &... • Answered on Mar 21, 2024
0helpful
1answer

2006 Nissan Xterra Security Issue

Is the security light lit up on the dash at all?What happens if you try to start the vehicle without unlocking the driver door with the key?Lastly, have you ever replaced the battery on your key fob? When their batteries get low, they can cause various problems that resemble mechanical faults or security problems.
3/19/2024 8:55:44 PM • Nissan Cars &... • Answered on Mar 19, 2024
0helpful
1answer

My partners 2009 Nissan Navara wont start. It makes a clicking sound but just wont start. It also has recently started overheating. The car does have alot of km's 399,000km's.

If the battery is OK the next thing to check is the starter motor itself. It usually shows as a single click or lots of fast clicks? For the overheating, how long after you start the engine does it start to overheat? If it takes a while, usually as the engine starts to get up to working temperature, the first thing to check is the thermostat. This is the most common thing to fail especially on higher mileage engines. Do this first as it's the cheapest fix. Next check the serpentine/Auxillary belt. A worn or damaged belt can slip slowing the pump down. This can also show as battery charging issues. Another cause of overheating is the waterpump failing. This can commonly be heard as a whine, chirp, or a squealing noise especially on a cold start. It can also often, but not always, be see below the pump as staining from it leaking.
3/19/2024 3:15:30 PM • Nissan Cars &... • Answered on Mar 19, 2024
Not finding what you are looking for?
2005 Nissan Almera 1.8 Logo

27 questions posted

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Almera Nissan

  • Almera Nissan

Most Popular Question

nissan almera tino ignition key comes

  • Cars & Trucks
Loading...