20 Most Recent
2007 Mini Cooper Questions & Answers
Mini cooper red elevated car warning light
That just means you're due for service. There's a counter in your on board computer that times out on things like brake fluid, coolant, inspection, air filter, spark plugs etc.. when one of those reaches zero, the car gives that signal to tell you to go in for service. Those must be reset with an external scanner. they can't be done by the driver.
I have a 2007 mini cooper I just bought and engine light has come on after about 100 mile's of driving
How many miles are on this vehicle? It might be that the trip meter has turned on. The MINI has certain preset service based on mileage. When the miles reach a certain number, the "engine" light will come on. Oil changes, maintenance markers (45,000-100,000) You will need that OBD2 unit to cancel the notice light. Probably should change the oil, check all other fluids, brake pads & rotors, etc...
Have fun'
-J
Radiator fan wont turn on on my Mini Cooper 2007
Most cars have a sensor about the size of your thumb that screws in to the engine block and tells the fan to turn on. There may also be a relay that is bad, and you may also have a bad fan motor itself. Throwing parts at the car could fix it, or a mechanic should be able to test it to find out which of the 3 is defective.
Be blessed.
Check engine light code p0014 exhaust and p0015 exhaust
P0015: Camshaft Position, Act B - bank 1, timing over P0014: Camshaft Position, Act B - bank 1, timing over advancedCheck oil level and quality.Remove n clean exhaust camshaft vanost actuator.Do not refit to exhaust cam, but swap with inlet actuator. clear codes...if eml on again see if fault moved to inlet cam. If so replace the actuator.
Code p0014 exhaust and code p0015 exhaust
The code P0014 is for Camshaft Positon Sensor Actuator Bank 1. The possible causes are incorrect camshaft timing, wiring problems (harness/wiring) in intake timing control valve solenoid system; continuous oil flows to VCT piston chamber or failed timing valve control solenoid(stuck open).The code P0015 is for Camshaft Position -Timing Over-******** (Bank 1). Your problem will probably be that the timing will be slightly out, due to wear (stretch) of the timing chain; this will all be linked to the overall cold start issue and the timing position. Get that timing checked, or push for the full fix for the cold start timing issue.
Not finding what you are looking for?