20 Most Recent 2008 Mazda 6 2.0 Questions & Answers

You could also try disconnecting the battery for an hour to see if it resets the system. Car wrecks disable many of the controls automatically. Often times you need to reset the computer by disconnecting the battery and reconnecting it.

Take the shroud off the part with the release button and see what's keeping it locked up. My recommendation would be to ditch those seat belts and replace them with airplane seat belts. They are much safer and don't break.

If the washers aren't spraying, the problem could be in the sprayer pump. Or the fuse for the sprayer pump. Or the sprayers themselves could be clogged. What is it doing, or not doing? Please be thorough. More info yields better answers.

Remove facia. Look for screws hidden under rubber strip which seals hood to cowl. Remove screws and pull away from windshield. Some require removing wiper arms first.

not anymore than any other front wheel drive car. are you having a noise(clicking or clunking) coming from the front only when turning. if so then you have a bad cv joint on the axle. its cheaper to replace the entire halfshaft(axle) than just the bad joint, as you get a rebuilt halfshaft complete. if you hear the noise when turning left then the left halfshaft is bad if you hear it only when you turn right then the right side is bad. you don`t say what issue you are having.

check 3-4 solenoid or pressure switch

this requires specail a/c equipment #1 removal and storage of refrigerant is required after that remove glove box then remove fan motor housing and connecting plenum then a/c box can be removed once the lines are disconnected . ice chest full of beers and patience . some time taking the seat out gives you more working space.

Remove the shift lever knob. Remove the #2 console panel by prying up with a flat screwdriver to release the clips. (The #2 panel is the one that includes your cup holders) Remove the #1 console panel (the one around the shifter) by prying straight up with a flat screwdriver to release the clips. Remove the screws securing the shifter boot (gaiter) to the bottom side of the #1 console panel.Reverse procedure to install.

first thing to do is get the car not to crank and check for power to the starter. if the starter has battery power and signal from the ignition switch then the problem is the starter. second thing is to check the plug at the trans range switch. the connector may be loose since you just had the trans repaired. ground may be an issue but not likely since the dash lights and other things work. GOOD LUCK.

It is on the outside of the transmission where the shift linkage connects under the hood.

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything someone on fixya recommended it to me and I thank him even today They have full manuals and it's verrrrry cheap and mine I got free in offers 3rd time I also had an issue with the file so the girl replaced it in 30 mins there is one more but i don't remember its name it was 2 years back bitman something link this Try it out brother