20 Most Recent
2007 Lincoln Navigator 4x4 Questions & Answers
Fuel filter location on a 2009 Lincoln Navigator
The fuel filter is located near the left side frame rail on the fuel tank. Insert a medium flat-blade screwdriver in the the fuel filter protective cover tabs, turn 45 degrees , and gently remove the cover from the tank, disconnect the fitting from filter..
12/28/2022 8:17:43 PM •
Lincoln...
•
Answered
on Dec 28, 2022
1999 Lincoln Navigator, turns over but wont start. I tried starting fluid, but still no start.
Question edited for clarity.
Question moved to Lincoln Navigator.
Any DTC Codes?
Did you disconnect the battery lately?
Is the Security Light flashing?
Do you have fuel pressure?
Check for spark?
The most common causes that hinders normal starting operation of your Lincoln Navigator are dead key fob battery
, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.Dec 17, 2020
Videos and more
https://www.google.com/search?q=1999+Lincoln+Navigator%2C+turns+over+but+wont+start
..
1/24/2022 7:45:34 PM •
Lincoln...
•
Answered
on Jan 24, 2022
Fuel pump driver module location
Fuel pump is actuated by the PCM. engine computer.The fuel pump module it self is in the tank. ie pump, gauge sending unit.
12/8/2021 12:18:41 AM •
Lincoln...
•
Answered
on Dec 08, 2021
Can i flat tow a two wheel drive 2008 Lincoln Naigator behind an RV?
this question can oficially be answered in either the owners' manual or by the dealer but I will state this..depending on how far you plan to go..it is usually better on newr vehicles to put them on either a dolly that supports the drive wheels or a trailer behind the rv..by drive wheels I dont mean the steering end.. I mean the wheels that get power from the engine.. this is due to the spinning of the driveline without the engine powering the transmission fluid inside.. sometimes this will tear up or wear out the final drive clutches and cause malfunctioning of the transmission..just to save your sanity..plan on using a tandem flatbed .. if you dont have one..u-haul rents them..the costs will offset a major transmission repair..learn how to load and tie the truck down for safe transporting..good luck and safe travels..
7/2/2019 2:04:57 AM •
Lincoln...
•
Answered
on Jul 02, 2019
2004 Lincoln Navigator
The blend door is plastic with plastic hinges that eventually break. If you go to a dealer, they have to remove the entire dash to get to it and it will cost you over $1000. There is an aftermarket door with metal hinges that you can replace by going through the glovebox and cutting through the duct. (You seal it later withe epoxy so it's airtight.) You also have to remove the center console, which is also how you can verify the door hinges are broken. Once I had all the tools and everything ready to go it took me about 3 hours. The fix will outlast the car (which has 463,000 miles, BTW).
3/16/2019 2:58:11 AM •
Lincoln...
•
Answered
on Mar 16, 2019
Heat an air not working in lincoln navigator
Could be the fan or the air flapper could be broken. The fan is simple conpared to replacing the flapper. The dealer will have to remove the entire dash and cost you well over $1000. There is a way to replace the plastic flapper with an after-factory replacement. You go in through the glove box and cut out a section of the duct and remove the old broken flapper, replacing it with new one. The newer version has a metal hinge and not plastic, which should outlast your car. Last, you might need to replace your climate control. I replaced mine with one from an Expedition from a junkyard.
3/16/2019 1:31:26 AM •
Lincoln...
•
Answered
on Mar 16, 2019
2008 navigator left turn signal stays on when in neutral position. Replaced turn signal lever to no avail
Principles of Operation
The smart junction box (SJB) monitors the multifunction switch position by sending multiple voltage reference signals to the multifunction switch. When the multifunction switch is in the LH or RH TURN positions, or the hazard lamp switch is pressed, that input signal is routed to ground.
When the SJB receives a request for a turn signal or hazard lamps, the SJB supplies voltage to the appropriate turn lamps.
The timed on/off cycle is determined by the SJB and is set to flash approximately 80 times per minute if both the front and rear turn lamps operate correctly. If an individual turn signal lamp is inoperative, the SJB flashes the remaining turn lamp approximately 160 times per minute.
Smart Junction Box (SJB) Diagnostic Trouble Code (DTC) Chart
DTC
Description
Action
B2A27
Right Front Turn Lamp Circuit Open
Go To Pinpoint Test M .
B2A28
Right Front Turn Lamp Circuit Short to Ground
Go To Pinpoint Test M .
B2A29
Left Front Turn Lamp Circuit Open
Go To Pinpoint Test M .
B2A2A
Left Front Turn Lamp Circuit Short to Ground
Go To Pinpoint Test M .
B2071
Hazard Switch Signal Short to Ground
Go To Pinpoint Test N .
B2281
Right Turn Switch Short to Ground
Go To Pinpoint Test L .
B2282
Left Turn Switch Short to Ground
Go To Pinpoint Test L .
All other DTCs
-
REFER to Section 419-10 .
Your best bet ,take it to a qualified repair shop . because i'am pretty you don't have a factory or professional scan tool to read these codes . Part stores can't read these code . And you probably don't have service repair info. for diagnosing one of these codes .
2/13/2019 7:12:16 PM •
Lincoln...
•
Answered
on Feb 13, 2019
Not finding what you are looking for?