20 Most Recent 2006 Kia Carnival 2.9 Questions & Answers

Go to autozone.com and create an account (free) Go to repair help and enter the year make and model of vehicle View Chiltons Repair manual

hi, you need the owners access code to deactivate the immobilizer as far as I know.

according to the data book code p2187 is "System too lean at idle, bank 1" and the probable cause is "fuel pressure, injectors, intake leak". hope that helps

I have checked the data sheet and I have no reference for the code you have given. All I can tell you is that it could be a poor or no connection to the air heater element or a wiring harness fault near the air intake air pipe.

it can be disabled by using the 4 digit code, found in the owners handbook, but needs to be connected to diagnostic equipment to do it.

The immobiliser can be disarmed by entering the 4 digit code in the owners handbook, but unfortunately the immobiliser can only be programmed when connected up to diagnostic equipment.

abs light should come on if anti brake system if failing and who quoted the price ..?

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

Also its advisable to go through this additional help links:----

Loss of acceleration? http://technoanswers.blogspot.in/2012/02/loss-of-acceleration.html

-----------

How exactly the Vehicles Accelerator Cable works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-cable.html

How exactly Vehicles Accelerator Pump Diaphragm Works? http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-pump.html

--------

stalls and bucks on Acceleration? http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

-------

Acceleration lag problem? http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html

---------

Car loses power while acceleration? http://schematicsdiagram.blogspot.com/2011/12/car-loses-power-while-acceleration.html

----------

This will help.

Thanks.

cylinder head the torque is : step 1 55 ft-lb, step 2 65 ft-lb, step 3 85 ft-lb. Rocker arm stud nut or bolt is 17 to 23 ft-lb. and valve cover bolt 72 to 108 in-lb.

There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few reliable-store .. let me know if u need help thanks

yes ,in front jumber box

Are you asking if this is the set up ? or what is the set up? Both inlet and exhaust cams are driven by the same drive belt, on the cam shaft, usually at the front of the engine