20 Most Recent
2006 Jeep Wrangler X Questions & Answers
Replace power outlet
with what. new oem or after market.
and why?
pull battery neg lug
remove socket
put in new
put back neg lug.
9/14/2014 3:41:07 PM •
2006 Jeep...
•
Answered
on Sep 14, 2014
Dashboard gauge needles irratic jumping on / off / fluctuating
Found out that irratic dashboard gauge needles jumping all over the place was due to computer harness connector pins getting a little corrosive / rusty.....
cured problem, over several times / applications by disconnecting harness, and spraying W\D 40 on pins (plugging in and unplugging several times), then wiping off pins and corrosiveness, and giving final light coat of W'D 40 and plugging in harness. Took a couple of times before problem disappeared over time.
2002 Jeep wrangler x. Hi my turn signals don't work.
nothing on dash means the whole IP cluster is dead.? (fuses)_
Fuses are first, repeat 3 times for effect.
front and rear turns dead or?
tell what does work all and does not,
telling just one thing bad, is not really usefull.
for sure power feed wise.
head lamps work and park?????? keyoff and on work.
horn works
brake lamps dead?
engine runs good.
I just sold my 2002 wrangler the last good real jeep it was, my bad selling it.
i have all jeep service manuals so easy to answer this 88 to 2010
on most cares I fix dead headlamps first it is hardwired to work at an any time and super simple if not DRL JUNK .
02 TJ jeeps (pure love)./
chapter 8w-52 'turns 'blinks, hazard]s
fuse 7 and 13 not blown
combo flasher not dead. 5 wires. and one pin is IGN, oops.
ign is fuse 13,oops, is it blown/
Hazards dead is same fuse and same InG fuse good.
IGN power comes form KEY switch page 8w-11
IGN switch wire BK-DG , 12vdc key on. if not fuse14 blown 20ams
and goes to the battery direct.
all fuses in the PDC must good, and now dead batteries
or its 4 cable logs ends, loose or rusty.
end.
fuse 10 and and F24 kills the cluster. and f15
fuse is 10 head lamps too and a CB breaker.
fuse 7 dead kills park /neutral switch ,
Check engine light on a 1999 jeep wranglertj
A check engine light means the computer found a problem. If the light is steady on, the problem may not be too bad, like a loose gas cap. If the check engine light is blinking, that's a major issue and you need to stop driving and have it fixed or major engine damage could occur.
Engine running lean
Check fuel pressure regulator for a rupture by pulling off the vacuum line and see if it is full of fuel.
'10' wrangler is starved for fuel when cold
You may have a bad coolant temp sensor but the only way to prove it is took hook into scanner that can read data, also check the fuel pressure. Note if the ect is bad it will be reading -45 no matter what the temp is it will get better as the lazy sensor catches up. I hope this helps, Take care
Not finding what you are looking for?