20 Most Recent 2005 Infiniti QX4 Questions & Answers

The can can't run. Why need to shift...?If you want to shift anyway. Be careful if down or up hill the car will roll.Here if need to shift away:-Put key in ignition, turn to start, but do not start.Now apply brake then shift.Mai Lor

I had the same issue with mine,and I went to the parts store and bought the best spark plugs and new plug wires and after I installed them it ran like new.

limited info generic answer no by-pass or hotwire thats movies -what is happening is vehicle turning over no start --no turn over--any dash lights [trouble ] on have vehicle scanned --check and examine key and ignition for failure

Look for a failing Crank sensor and/or the cam position sensor. A diagnostic test will tell you for sure.

The Starter Inhibiter Relay is usually located behind the fuse panel under the dashboard. I presume your QX4 won't start or is having a no-crank condition?

The knock sensor is on the cylinder block. Concealed from sight because of the intake manifold.

Have the exhaust flow tested for a clogged catalytic converter, and have the fuel injectors bench flowed and cleaned.

# 6 have fun ..

do try the distributor 1st, also p0325 is not an mil item

pull one ignition cable out of cap just enough to see the tip of connector and crank it, a spark should jump from cap to tip of wire. no spark means you need the whole distributor replaced. buy it from nissan or infiniti dealer, it comes with cap rotor installed and 12 mo 12k mile warranty, no matter who installs it. dont waste time with aftermarket rebuilt distributor, those are not reliable. https://parts.infinitiusa.com/

Open the rear lift gate, the cap is there in the door opening.

If it isn't not working...doesn't that mean it is working?