20 Most Recent 2009 Infiniti FX35 4WD - Page 6 Questions & Answers

Check your fuses for starters

https://www.obd-codes.com/p0600

Someone will answer that---- when you provide no product !!!

Whut? Cars have never had an oil level view unless you were driving a steam powered traction engine :>D The only things that show full to empty are ; Fuel tank Water temperature Battery amps charge Oil PRESSURE (possibly) This is NOT the level. Engine oil in EVERY vehicle is checked by a dipstick which is on the front of the engine block. https://www.infiniti-cars.co.il/content/dam/Infiniti/Israel/car-books/Infiniti_QX60_ENG.pdf Page 15, item 12 Page 448 tells you how to check the oil level.

https://www.bing.com/videos/search?q=2003+infinity+m45+hvac+recharge+port+location&&view=detail&mid=1AABE1647A1633A1E3BA1AABE1647A1633A1E3BA&&FORM=VRDGAR&ru=%2Fvideos%2Fsearch%3Fq%3D2003%2520infinity%2520m45%2520hvac%2520recharge%2520port%2520location%26qs%3Dn%26form%3DQBVR%26sp%3D-1%26pq%3D2003%2520infinity%2520m45%2520hvac%2520recharge%2520port%2520location%26sc%3D0-45%26sk%3D%26cvid%3D1B0C46F132A14B9C9B54F6E9CF387F83

limited information generic answer start with testing and checking battery alternator and wiring connections

With the hood up, the dipstick should be on the left side towards the middle . Under the windshield wiper so way up front.

not reading key or immobilizer [security ] circuit failure https://www.engine-codes.com/p1611_infiniti.html

Use your OBD code reader.

Reset the alarm memory as it thinks the vehicle has been stolen.

Antifreeze leak. Dont run the engine without checking the level

If you are getting power to the switch, make sure you are getting power to the motors when the switch is moved. If so, make sure the motors have a good ground. If not, check the fuse box. If you have power to the switch and the switch is sending power to the motor and the motor has a good ground. you have a bad motor. If you have power to the switch, but are not getting power to the motor, you have a bad switch. If you don't have power to the switch, you might have a bad fuse. If you don't have power to the fuse, you might need to check a wiring diagram to see what feed power to that circuit in the fuse box.

Swingit into a partstore for freehelp. They may hav some lube for it allso

It's fuse #41 in the under hood fuse block,

Quit guessing and have ABS codes read. Symptoms would be indicative of a bad wheel sensor which often fail with hub/CV failures.

https://www.clubarmada.com/threads/erratic-tachometer.17405/ This thread has several suggestions from a failing battery to bad grounds or BCM problems.

Starter probably going out. Try banging on it with a light hammer or screwdriver, then see if it will work. If it works now, it definitely needs replaced. If your security light goes out after a couple of seconds of turning the key to ON, the security system is working right and not a problem.

Any chance u got a manual to refer to since it looks something that happens not very often.. like get reference books from reliable-store.com .. I'm kinda sure that's all u need..

If the "dead" battery has a shorted cell, jumping doesnt always work.

Put the dead battery on a charger for an hour and see if it takes a charge. If it doesnt take a charge, replace.