2011 Hyundai i10 - Answered Questions & Fixed issues
Petrol block in carburator
There have been no carburators used on a car in 25 years or moreYour question also doesn't address the vehicles real issues,starting,idle,driving,lack of power & suchIs that not under dealer warantee?
2016 Hyundai i10. Should both fog lights come on when side lights switched on?
Question edited for clarity.Question moved to model category.Duplicate questions x 2 deleted. Refresh page to see your post.No, low level fog lights are for use in fog only to reduce glare back to the driver. You have one bulb that need replacing on the offside and you need to turn them off on the lighting stalk. Also as you have the U.K. version make sure you only use the high intensity rear guard light when visibility is 500 yards or less. I live in Canada now and people with European cars (Volvo, Mini, Fiat) have no idea when to use them and blind other drivers on the motorways in clear weather.Page 146 of the manual - Section 4-69.OWNER'S MANUAL
hyundaimotors.co.ilhttps://www.hyundaimotors.co.il > i10-engThis manual applies to all Hyundai models and includes descriptions and ... Page 8-6 in the Vehicle Specifications chapter of the Owner's Manual.452 pages..
Valve clearance Hyundai i10 4 cil. 1.1 l
The valve clearance specifications are as follows:
• Engine coolant temperature: 20°C [68°F]
• Limit Intake : 0.10 ~ 0.30mm (0.0039 ~ 0.0118in.)
• Exhaust: 0.20 ~ 0.40mm (0.0079 ~ 0.0157in.)
Also, look at your car's owner's manual ato figure out how to check your valve clearance once you've put about 60K miles to it, and there it will also tell you what the specifications should be.
Hyundai i 10 1.2L 2014 fog lights not working. How do I proceed
If the fuses are fine I would pull the bulbs out of the fog lights and check them to see if they are burnt out you could also use a test light on the bulb holder turn the fog lights on in the vehicle take test light and test both tabs in the connector one should have power and other side will not if bulbs look good and there’s no power coming to the bulb connector the switch might be bad or could have a break in the wires coming from the switch. Hopefully this will help
How to adjust rear brake and handbrake on Hyundia i10
look in your centre console between the seats and remove the bottom of it this would usually just pull out then there should be the end of your handbrake cables with a 10mm adjustable nut that you can get a spanner on ,obviously make sure your car can not roll and release your handbrake wind the nut in a couple of turns then try your handbrake ,keep doing this until it reaches your desired height
Hope this helps Nick
Hiyundai i10 power streering problem
you can ask for a part number & try to buy it from another source.
you can ask that they return the old item to you after replacement, the part numbers on the invoice & on the old unit should match.
If I replace my ecu with a secondhand one for my hyundi I 10 do I need to code the key
No, the ecm must be programed for the car. I am a Kia mechanic and Kia is the sister company to hyundi like Honda to Acura. You cannot put any ecm in cars now a days. The ecm Kia has are one shot deals. They can only be programed once. Napa, car quest, can get new elms cheaper than the dealer in most cases, but you will still have to tow it to the dealer to be programed for the car.
Fuse box its heating
this is a hazardous situation, check to see if the fuses are secured properly, before continuing, normally one or two fuses are loose in the housing causing a hotspot.
Not finding what you are looking for?