20 Most Recent 2005 Hyundai Getz 1.3 Questions & Answers

Question edited for clarity, too many words :>D Question moved to model category. They are all in this link https://www.hyundai-forums.com/threads/hyundai-getz-1-3-2005-g4ea-big-end-torque-settings.639857/

Hyundai Getz 2003 1 1 1 3 PDF

Scribd https://www.scribd.com > document > 138325436-HYU... Tightening torque Main bearing cap bolt 1.3: 55 ~ 60 Nm (550 ~ 600 kg.om, 41 ... big end bear- ing. Crankshaft end play 1.3L: 0.05 ~ 0.175 mm (0.002 ~ 0.005 ... ..

See about getting an OBD reader from some place like autozone. They loan them. Plug it into the car receptacle and see what codes are present. This sounds like the crank shaft sensor is bad.

did you replace the clutch plate as well as the clutch ? as not doing so it can be warped from the heat of old one burning out. also did you check the flywheel as any imperfections in the plate can cause clutch wobble.

Batteries in remote. Or blown fuse. Make and model year would also help answer this question. Thank you

this will be from a faulty master cylinder wit a blocked compensation port pads are dragging and building up heat which is expanding the brake fluid and as it cannot get back to the reservoir it puts the pads on harder it is also evident if you apply the brakes and the car takes extra power top move off I suggest that you take it to an accredited brake specialist and get a proper diagnosis and a quote for a new master cyl

unbolt it from the brackets behind the bumper

Check with a multi-meter that the switch itself has a open/closed function(ohm meter setting)Hope this helps....

Check your brake fluid...............