20 Most Recent
2006 Holden Barina Questions & Answers
Hi i have barina 2006 manual and it wont go in reverse anymore, someone told me to get new master slave cylinder but is that what will fix the problem or what else? Thank you
The best solution you'll get from books at
www.reliable-store.com
These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wirin
g diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc
2006 Barina manual. Driving, suddenly clutch doesn't engage on take off. Waited and then it grated and worked. Temp of car suddenly rises, air con then blows hot air. Stop, engine super hot
The only scenario that i can think of that could create all of your issues is your clutch is and has been slipping for some time. All other train of thoughts really don't make sence. This would give issue either selecting a gear whilst driving or possible slecting gear and engine speed raising but vehicle not moving from a stand still start on sharp pull away. Engine speed would be running higher than required most of the time which would increase engine temp considerably. Due to extreem engine temp your air con would probably switch off as to not put additional load on your engine creating even higher tempratures. My advise is It really needs a visual / test drive to confirm a diagnosis by a qualified person for this information to be confirmed. I hope this makes sence good luck.
Central locking making loud clicking sound
Try opening the door from the outside (or get someone else to do it for you) whilst sat in the car to see if it still does it. Then lift yourself off the seat and see if it stops. If it does stop whilst you are not sat down it may be a problem linked to the seat occupancy switch that activates when you sit down.
Instrument panel has frozen what could be the possible cause of this.
Check fuses for Steering control module and connections to back of Display, same thing happens on Volvos usually fuse or heatsink on display control IC gets hot due to heat paste drying out clean and replace if possible or seek service agent , An OBD reader may possibly show up fault so you need to get a scan of the DT faults your local garage will do this quite cheap for you.
How to diagnose a noise from around the engine.
buy a mechanics stethoscope at the auto supply.it is well worth the money.
Have a listen to the pulleys. do not touch moving parts!
just the stationary bolts.
listen to the alternator as well. an alternator can make alot of noise if the bearings are gone.
Not finding what you are looking for?