20 Most Recent 2005 Ford Freestyle SEL Questions & Answers

Problem could be either a faulty or out of balance tire. If the place that balances them for you is half decent they will be able to inspect and tell you if you have a faulty tire.

The Internet, though, has a large number of web sites where you can buy service manuals and schematics from bookstores, publishers, and other collectors. Here is just a sampling of what sites are out there: Chilton Repair Manuals http://www.chilton.cengage.com/ Factory Auto Manuals http://www.factoryautomanuals.com/ web based auto repair manuals Haynes Publishing Haynes is the information resource for the DIY enthusiast

The fill plug should be on top of transaxle.

You put it in the transmission dipstick tube which as you have seen is at the right hand end of the engine near to the battery. Use a narrow funnel or a turkey baster.

You need to to hook up manual fuel pressure gauge and go from there. also see if any pcv hoses came loose., sometimes aftermarket air filter comes apart and it will clog up the air intake. Pull the mass air flow sensor and look inside if any dirt or some little bugs got sucked in.

Torque spec is 200Nm / 148 ft lbs for the axle nuts front and rear

could be a loose exhaust system component and when the pipes get hot they expand and close the gap check all pipe joints and also if you can get someone to start it while the hoods open and you listen on the sides of the motor it could be also a loose exhaust manifold are you smelling exhaust fumes or have you been getting headaches since this problem arose or feeling a little out of it if so go to a muffler shop and let them check the vehicle your life depends on it ok but if you can feel air coming out of any pipe joint or exhaust component get it fixed asap! o.k.

YES YOU CAN GO TO WHERE THE LIGHT IS YOU'LL MOST LIKELY HAVE TO OPEN THE LIFTGATE YOU WILL SEE PLASTIC HOLE FILLER BUTTONS POP THOSE OUT AND THERE SHOULD BE SCREWS THERE OR THE BUTTONS WILL BE THE CLIPS THAT HAVE SERRATED ENDS THAT FIT IN THE HOLES TO HOLD THEM IN PLACE GRAB THE BULB RETAINERS AND TWIST THEM OUT AND REPLACE WITH 2 NEW ONES IS THE BEST IDEA

you can go to autozone.com they even have videos that show you how.

P0171 means your fuel mixture is not right in one of your banks, (left or right, if straight engine only 1bank), try cleaning your maf sensor

Limited information generic answer Check the shifter linkage if good Re check fluid it if looks dirty ( not burgundy) you can try a flush and fluid change

It's in the transmission and why do you want to do that?

i know a web site that has very good manuals online, without expiry i.e. for lifetime. www.reliable-store.com

if the hater is from the weep hole under the pump housing, it indicates that then pump shaft seal has failed ' a replacement pump is the fix