20 Most Recent 2008 Ford Bantam 1.6i Questions & Answers

It is plugged into the transmission where the speedo cable would go in older cars.

Mine did the same it was the spark plug wires that was fault

On this website (link below) you find fuse box diagram and description for Ford Bantam Ford Bantam 2002 fuse box diagram Auto Genius

Sometimes when the batery of vehicle goes flat or when u fit a new car batery to the bantams they love to give that problems like gauges not working rpm not working speedo not working and cluster display is dead, u disconect the batery termanils and for example fit positive termanil and arc. Or short til that blue spark occur then u swop around negative on and arc positive,leave the ignition switched on arc til gauges move!! Don't ask me why but that happend to me! A autoelek friend of mine showed me this! NB don't tri this with vehicles with a lot of elektric featers it can cause demage to ecu (engine control unit)

your best off getting a repair manual, so you can make sure you get do it all right 25.00 is little to pay. for so much info.

The receiver wraps around the ignition switch. You have to remove the steering bezel to access it.

Bad alternator or wiring xposed causin short. Chec befor a fire starts

run the fault codes to find the faulty sensor.

timing is set through the ecm there is no manual adjustment

USUALLY A DIAGRAM/PICTURE SHOWING FUSE LOCATION/NUMBER IN YOUR OWNERS MANUAL. LOOK IN INDEX UNDER FUSE.

if it rocam engine it does not have a belt it runs on a chain