20 Most Recent 2007 Ford Bantam 1.3i Questions & Answers

Bad oil pump? Bad bearings? Bad sender unit, but with bad noise probably the engine needs overhaul or replacement.

Any multipurpose engine oil should do. Just be careful with synthetic oil.

Look up Tradebit on web,get a 2002--2008 manual download. Anthony.

Could be a problem with intermediate steering shaft may you can try to put some oil.

Attach a mechanical oil pressure gauge to see what's up.

depends on where it snapped. If it is accessible under the dash, clamp some vice-grips on it and pull. If it is broken somewhere under the bonnet it gets a lot trickier as you'll need to find a way to trip the latch. Reply as a comment if we need to explore that.

generally, if u get under it u will see a couple of straps that are bolted to the bed. Remove the fuel. Disconnect the fuel line. block the opening and fill the tank with water. Disconnect the filler hose, and wires. unbolt

there are some products at an auto parts store made for that problem. Just be careful about static electricity, sparks and flame.

Replace tank.

That is a vague question. If in doubt use standard bolt torque along with some common sense.

did you recon the rad it may be corroded all ways replace rad when you recon an engine but a handy way to see if the pump is working is to see if the water is returning into the header tank

Check fuel filter for air leaks also pump

torque settings for what part ????

thats going to be a dealer item

This is (obviously) a two-speed motor. The low speed winding is burned out. Replace the motor.