2004 Citroen C2 VTS - Answered Questions & Fixed issues

Do you mean it revs too high, or dies? Check EGR as most common issue, then IAC motor, coolant temp sensor, O2 sensor, tune up items.

Hi Nadeem I had a similar problem with my Toyota Hilux, it turned out to be the brake light switch. While driving, dab the breaks just enough to trigger the brake lights, if your motor cuts out then it could be the brake light switch

Hi, If you are trying scan a VW group car, you need a VAGCOM software and interface VAGCOM, with easyobd2 is no compatible protocol, best regards

Certainly sounds like a fuse/fuses very unlikely multiple systems would fail together but if they are grouped under the same fuse/fuses then the chances are that's the problem. very easy look at the fuse section of your owners manual to identify the fuse/fuses pull out the fuses and replace with new ones of the same rating rating is in owners manual and on the fuse itself. If it works then you know that's the problem. ps if it doesn't have your battery checked as low charge can cause electrical glitches.

https://www.google.co.uk/search?q=citroen+c2+front+suspension+diagram&ie=UTF-8&oe=UTF-8&hl=en&client=safari Try this link. Gives all torque settings in both nm and ft/ lbs

Try this link https://www.google.co.uk/search?q=citroen+c2+front+suspension+diagram&ie=UTF-8&oe=UTF-8&hl=en&client=safari

Without knowing which light, cannot help. Have you a user manual, check there.

Can you be more specific? Could be dry bearings, shot shocks, pivot bearing dry/seized.

Duplicate question.

try to recheck the spark plug distribution cable arrangement otherwise check your spark plug may be one of it is short or the gap is not proper.

That is a whole lot of 'not working'! Check the fuses, but you probably need an auto-electrician. https://www.google.com/search?q=citroen+c2+fuse+box+diagram ..

There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few . reli able-store let me know if u need help thanks

Check all the connections on the devices that you worked on, battery, alternator etc.

photos for this timing

Go to www.radio-codes.com

The only thing I can think of is that this make uses an electric lock actuator and the key just turns on a switch, with no battery power no lock action.

Alignment will be able to correct that at 100%

You remote (plip) needs new battery: CR 0523 (3V). After a change of battery, it may be necessary to re-initialise the remote control. To do that, switch on the ignition and immediately press "lock" button on your remote control to trigger the action desired. This may take some ten seconds.

Connect to Lexia 3 scanner to re code key and radio.