20 Most Recent 2005 Citroen C2 Questions & Answers

Google it, but best to google by engine supplied in your vehicle rather than by brand: (engine) connecting rod torque I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

on your citroen a lot works thru your radio connections check to see if they can be bypassed in anyway-reconnected

What's the engine?

what does the scan tool show.?? ? still P0106, and did you reset it? did you try to start car with MAP disconnected, some do start in limphome mode. rich a a pig but starts. did you have key off when you fiddled the MAP connector, or better pull the battery neg, lug first? lost power to the mAP, check the power pin. lost ground to sensor. lost vacuum to the sensor (clogged paths) Bad MAP sensor Water/dirt intrusion affecting MAP sensor connector Intermittent open in the reference, ground, or signal wire for the MAP sensor Intermittent short in the reference, ground, or signal wire for the MAP sensor Ground problem due to corrosion causing intermittent signal problem A break in the flexible air intake duct between the MAF and the intake manifold Bad PCM (do not assume the PCM is bad until you've exhausted all other possibilities)

That is a whole lot of 'not working'! Check the fuses, but you probably need an auto-electrician. https://www.google.com/search?q=citroen+c2+fuse+box+diagram ..

There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few . reli able-store let me know if u need help thanks

Check all the connections on the devices that you worked on, battery, alternator etc.

photos for this timing

Go to www.radio-codes.com

The only thing I can think of is that this make uses an electric lock actuator and the key just turns on a switch, with no battery power no lock action.

Alignment will be able to correct that at 100%