20 Most Recent
2005 Chrysler Pacifica Touring Questions & Answers
Windshield Washer Pump connection to the water bottle
Take the rubber hose loose at the nozzle, try the washer. if water comes out then the little hole in the nozzle is stopped up. Use a small needle or stickpin to clean it out while someone works the washer switch.
How can i fix a p0522 code that is read by my engine light? Can i reset it and forget it? Or is it dangerous?
code p 0522 refers to engine oil pressure sensor/switch---low voltage === causes --wiring short to ground ---engine oil pressure sensor/switch---ECM
any reference to oil pressure warnings should be taken seriously as a destroyed engine is a result of inaction
first get it to an accredited service shop that handles your make of vehicle and have the oil pressure checked with a mechanical gauge
if it not a pump/ oil level problem , replace the sensor
Oil light stays on when engine is started
If oil level is okay and the engine has pressure like no knocking the sending unit is bad. The dealer will charge about 85 to change it don't even try to do it yourself. It took a garage 6 hours to change it. It is in a bad spot and unless you want to rip the connector of it and hope it stays on the new one, it is easy to do . If you want it done right take it to the dealer
What's the difference between the master cylinder with or without traction control
The parts-store gave you the wrong part. If you still have it, take the old part with you to the parts store. Just match it with the new one before you pay for it.
As for the traction-control matter, the difference has little to do with the master cylinder. In traction control, a computer and wheel-mounted sensors keep the wheels from skidding by turning the hydrolic pressure on and off to the individual wheels according to which one is or is not skidding.
What fuse do I need to change to make my temp light come on; on the dash board any make temp blow
Is this the only light that is out? If so the bulb has failed. You would have to change the bulb. Pop the plastic cover over your instrument cluster, Unscrew the instrument cluster (4 screws) , pull towards yourself .The bulb is behind the temperature gauge. There you will find a holder of the bulb, turn left or right to unscrew remove and change the bulb. I believe it to be 194. When installing bulb wipe clean with cloth and don't touch. Skin oil tends to make for short life. Install bulb and go in reverse till all is together. GOOD LUCK FRIEND.
Not finding what you are looking for?