20 Most Recent
2007 Chevrolet Impala - Page 2 Questions & Answers
How to disarm after market alarm on a 2007 chevy impala
That would depend on what kind , how it works , power supply etc.... You mite what to have it towed to a repair shop , that is if it won't start . You could very easily make your vehicle useless . cutting wrong wires . I'm sure you have no idea of the computer systems on your car an the serial data network that all those computers share information on .
How to Diagnose Controller Area Network CAN . We are here to help an give you are best suggestions . Without looking at it ,seeing how it's hooked up . I just couldn't say .
2007 chevy impala oil light on
Could be a big problem. Check switch first. If switch is fine check for oil pressure using a pressure gauge plugged into oil sender hole.
My 2007 checy impala read "calibration complete" what does that mean ????
CALIBRATION COMPLETE
Refer to
Electronic Compass Calibration do you have an owners manual ?
Compass Calibration
The compass direction will show CAL if it needs to be calibrated. Before calibrating the compass, drive the vehicle to an area that is magnetically clean (free of large metallic objects).
- Turn ON the ignition.
- Before calibrating the compass, make sure the compass is set to the variance zone in which the vehicle is travelling. See Compass Magnetic Variation Adjustment below.
- Press the vehicle information button until the PRESS TO CALIBRATE COMPASS screen is displayed.
- Press the set/reset button to start the compass calibration.
- The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE when the calibration is complete.
How can I remove steering gear?
There is no steering gear, or gear box on this vehicle this year ,make and model you are asking about has rack and pinion steering you must lower the back of the engine cradle or frame to get to it depending on the suspention package on your vehicle you may also have to remove the sway bar in order to get to the bolts that hold it to the frame , you will need to remove the tie rod ends from the spindles and tie off the steering wheel so it does not flip when you disconnect the steering shaft this is a precautionary measure in order not to break the clock spring in the column for the air bag. You will also have to remove the driver side tire after all of the bolts lines and nuts are removed it can be slipped out through the driver side wheel well reassembly just reverse the process and you will need a alignment afterwards
How to put freon in a chevy impala 2007
Discharging, evacuating and charging the air conditioning system must be performed by a properly trained and certified mechanic in a facility equipped with refrigerant recovery/recycling equipment that meets SAE standards for the type of system to be serviced. If you don't have access to the necessary equipment, we recommend that you take your vehicle to a reputable service station to have the work done. If you still wish to perform repairs on the vehicle, have them discharge the system, then take your vehicle home and perform the necessary work. When you are finished, return the vehicle to the station for evacuation and charging. Just be sure to cap ALL A/C system fittings immediately after opening them and keep them protected until the system is recharged.
Not finding what you are looking for?